7MMGDX655EW0 Whirlpool Dryer - Overview
Sections of the 7MMGDX655EW0
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Dryer Handle (White)
PartSelect #: PS11731583
Manufacturer #: W10861225
This white OEM dryer door handle is used to open and close the dryer's door. Comprised of plastic and 6-by-2-inches in dimension, the handle is sold individually and attaches to the dryer door. Your d...
$49.31
In Stock
Dryer Idler Pulley Assembly
PartSelect #: PS11743765
Manufacturer #: WP691366
This part provides the tension required for a multi-ribbed belt. It also helps the belt rotate the drum and attaches to the idler pulley wheel. If your dryer will not start or tumble, takes too long t...
$15.68
In Stock
Dryer Drive Motor w/Pulley
PartSelect #: PS334304
Manufacturer #: 279827
This motor fits most Whirlpool incorporated dryer brands before 1996. NOTE: Pulley is NOT available separately.
$92.56
In Stock
Dryer Drum Felt Seal
PartSelect #: PS8691753
Manufacturer #: W10612022
This is a genuine OEM replacement rear drum seal for your dryer. This seal is made of felt and comes with the adhesive required for installation. The purpose of the seal is to prevent hot air from esc...
$40.95
In Stock
Dryer Liquid Propane Conversion Kit
PartSelect #: PS3493998
Manufacturer #: 49572A
This part converts your appliance from Natural Gas to Liquid Propane.
$32.51
In Stock
Door Gasket
PartSelect #: PS11731610
Manufacturer #: W10861521
This door seal does not include the adhesive glue.
$48.95
In Stock
Dryer Drum Roller Shaft Left Side
PartSelect #: PS11753706
Manufacturer #: WPW10359270
Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and...
$49.30
In Stock
Belt
PartSelect #: PS11750135
Manufacturer #: WPW10198086
This authentic OEM drum belt is designed to fit with various models of dryers. The belt is a narrow strip of rubber that wraps around the drum and connects it to the dryer motor. This allows the drum ...
$50.37
In Stock
Stacking Kit
PartSelect #: PS888067
Manufacturer #: 8541503
This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.
$45.10
In Stock
Dryer Drying Rack
PartSelect #: PS346849
Manufacturer #: 3406839
This dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits dryers that are 29 inches wide, have the letter "E" following the numbers in the model num...
$53.41
In Stock
Relay PTS
PartSelect #: PS11756343
Manufacturer #: WPW10563095
Introducing the Relay-PTS or Push-to-Start switch from Whirlpool - designed for optimal performance and reliability. This genuine OEM part of superior quality works seamlessly with selected models of ...
$56.98
In Stock
Questions And Answers for 7MMGDX655EW0
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the 7MMGDX655EW0
[Viewing 8 of 8]Noisy
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Drum Not Spinning
Fixed by
these parts
these parts
Show All
Marks left on clothes
Fixed by
these parts
these parts
Show All
Won’t Start
Fixed by
these parts
these parts
Show All
Door Pops Open
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Too hot
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Make humming noise when pressing start button. Would not start
After looking on the website for advice I walked throught the simple steps of disassembling the front, removing the drum, removed the back, disconnected the wire harness. Then removed the blower housing in the back. The blower, mounted on the back side of the motor was very tight. I used a pipe wrench wedged in place and help by my 10
... Read more
year old Grand-daughter while I used an adjustable wrench to turn the shaft on the front of the motor. Spun the blower off, removed the two clips holding the motor. Then reversed the process when I received the new motor. Care should be taken to avoid damaging the blower fan if a lot of pressure is required.
Read less
Parts Used:
-
James from Moscow, IA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
97 of 111 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The handle to the dryer broke.
-
Dawn from AUSTIN, TX
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
73 of 82 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rear Dryer Seal was old and staining clothing
After unplugging the dryer,I removed 2 bolts on the back top of the dryer, then removed the two screws in the lint box area. I used a screw driver to help force the top panel of the dryer up. When open, I removed the top screws that held the front and side panels together. I then lifted the front panel up and away from the dryer, so there
... Read more
would be room to take the drum out. I removed the belt from the pulley (located under the drum) and slid the drum out. I removed the old seal, cleaned up the drum and the inside of the dryer, then glued the new seal on. After the glue was dry, I put the drum back in (with the belt on the drum), put the belt back on the pulley and proceeded to put the dryer front back on. Once the front was on, I put the top back on and replaced the bolts on the back of the dryer. I plugged it in and it is working great! By the way, before this, I had NEVER attempted to repair a dryer before and I am female. If I could do it, so can anyone else willing to try :)
Read less
Parts Used:
-
Grace from Phoenix, AZ
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set
58 of 65 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!