Models > 650C > Instructions

650C - Instructions

All Instructions for the 650C

Spring on clutch cable broke

Remove L. wheel.
Remove guard shield.
Remove old cable.
Install new cable.
Adjust throw on cable.
Put all parts back and test

Parts Used:

Tiller Clutch Cable

David from SKANDIA, MI
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

replaced old belt

took cover off and replace belt

Parts Used:

Belt, V

David from WINSTON SALEM, NC
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Socket set, Wrench set

4 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Gas tank leaking, pull starter rivets worn, rope and rope bushing worn

The gas tank was a simple job, close the fuel shut off, remove fuel hose then back out 2 bolts on the mounting bracket. Reverse procedure to mount.
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill switch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light

Parts Used: