Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This genuine bump head knob assembly, sometimes known simply as the bump head, is black and approximately 2 inches long. Sold individually, this plastic part releases the cutting line. Over time, this...
$14.78
In Stock
Order now and your part arrives in 2-3 business days!
It is an authentic manufacturer-sourced replacement part that i supplied for Craftsman trimmers. The function of a carburetor is to mix the air and the gas into a highly combustible mix before it goes...
$39.54
In Stock
Order now and your part arrives in 2-3 business days!
This clutch assembly is a genuine OEM replacement kit for outdoor lawn equipment. The kit includes the clutch drum, clutch, clutch washer, and screw. The clutch assembly transfers power from the engin...
$28.58
In Stock
Order now and your part arrives in 2-3 business days!
This spool is for line trimmers.
Spool houses the cutting line and fits inside the cutting head to cut grass and weeds.
Wear work gloves to protect your hands when installing this part.
$24.40
In Stock
Order now and your part arrives in 2-3 business days!
This is an OEM insulator assembly that is used to protect the carburetor from engine heat and features various seals and hardware made of plastic, steel and rubber. It fits in between the carburetor a...
$8.45
In Stock
Order now and your part arrives in 2-3 business days!
1. Remove Shaft & clutch cover by removing 3 torx screws and loosening cinch bolt.
2. Remove clutch assembly with torx tool in center and then by cinching the shaft and turning spring assembly counter clockwise with an adjustable wrench.
3. Remove starter housing by removing 3 Torx bolts from the front and a screw
... Read more from the back.
Drive shaft replacement was very easy . Minimal tools were required. Just disconnect the throttle cable, mainly for easier movement of trigger handle. Then remove the guide handle and the trigger mechanism and base. Reassemble reverse order.
