Models > 323S25 > Instructions

323S25 (967078401) Husqvarna Sprayer - Instructions

All Instructions for the 323S25

Drive belt came off from transaxle pulley, noticed in bad shape, ordered new one form parts select.

The drive belt literally goes from the back of the tractor to the front. The mower must be removed, helps to have the tractor up on blocks to give adequate room for work on underside. Belt goes easiest on the engine first, then thread to the rear, install on the rear, (driven pulley) then on the idlers. Check to assure that it functions properly before re-installing the mower. If you have the owners manual, there is a diagram, (check your orientation, it is not clear if it is a birdseye or under tractor view) which offered some help. When replacing belt, check the transaxle front mount, mine was broken which is why the belt came off in the first place. Repairing the mount was quite a job in itself, but now works fine.

Parts Used:

V-Belt-Drive

Lynn from BOILING SPGS, PA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Socket set

20 of 32 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Take the wheel off. Place the key in the slot. Put the wheel back on.

Just described it.

Parts Used:

Lawn Mower Key

Gary from PILESGROVE, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

5 of 11 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Broken weld on right axle

Removed wheel (used strong magnet to catch the keeper)
Removed axle assembly from its mounting tube
(used strong magnet again to prevent keeper lose)
Installed replacement axle (again with the magnet)
Lubricated with 90 SAE
Re-installed the wheel (used magnet again to hold the keeper.
Mowed the lawn.

Parts Used: