All Installation Instructions for Husqvarna Leaf Blower / Vacuum 155B

Wheel bushings were bad

Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.

Parts Used:

Lawn Mower Ring Clip

Lawn Mower Axle Hub Cap

Anthony from OLIVEHILL, TN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

22 of 36 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Take the wheel off. Place the key in the slot. Put the wheel back on.

Just described it.

Parts Used:

Lawn Mower Key

Gary from PILESGROVE, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

5 of 11 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Dryer runs no heat

Disassemble dryer. Replaced element assembly. Re assembled dryer. Unit runs and heats.

Parts Used:

Solenoid

Lawn Mower Ignition Switch

Russell from MACON, GA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Lound deck noise when mower put into motion

Parked mower on level concrete drive, laid on cardboard. Lowered mower deck all the way. Sparayed some WD40 on nut/bolt on top of old pulley. Since it is a carriage type bolt, placed 5/8" boxed end wrench over self locking nut on top of old pulley. Using some force from 3lb mallet to break nut free (hitting against wrench body), the nut came off easy as did broken pulley/bearing inside. Installed new pulley assembly, re-tightened nut on bolt. Checked after first mowing just to be certain pulley was in place and locking nut tight.

Parts Used: