Parts That Fix Kenmore Refrigerator 10651123210 Ice maker won’t dispense ice

This white ice bin auger drum comes with a washer.

This part attaches to the drive shaft of the ice dispenser motor.

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice door out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

Bucket only. All other parts sold separately. This part holds the ice once it's released from the icemaker.

This kit includes the module motor, ejector arm, and ice stripper arm. The complete icemaker is sold separately.

The crisper drawer (Crisper Pan, Refrigerator Crisper Drawer) with humidity control is meant to keep your vegetables and fruit as fresh as possible by allowing you to regulate the humidity levels within the drawer. It attaches on the inside of your refrigerator to the bottom of the crisper shelf. This drawer can break from misuse or accidental damage. It is also subject to material fatigue over time. If broken or damaged, it may be difficult to slide the drawer in and out, and it should be replaced. This plastic drawer measures 14.92 inches long, 7.6 inches high, and 16.5 inches wide and comes in white/clear.