10350 - Overview
Models starting with 10350
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Dryer Screw
PartSelect #: PS11746840
Manufacturer #: WP90767
This screw is sold individually.
$7.95
In Stock
Sander Rotor & Blade Set
PartSelect #: PS10338983
Manufacturer #: 57113
This is a genuine Dynabrade replacement part designed for use with sanders/buffers. It fits inside the cylinder assembly. This set includes a plastic rotor and a set of five (5) blades. To replace it ...
$93.19
In Stock
Microwave Ceramic Fuse 20 Amp
PartSelect #: PS11747931
Manufacturer #: WPM0805101
This microwave fuse is just over an inch in length. It has a white ceramic center, and metal on either end. This is a twenty amp 250-volt fuse, and is used to power your microwave. If your microwave w...
$9.95
In Stock
Range Heat Resistant Adhesive
PartSelect #: PS11728058
Manufacturer #: W10841140
This is a heat-resistant adhesive for your appliance. The heat resistance allows you to stick parts such as grate feet, gaskets, and felt seals in hot areas, such as a cooktop, without compromising th...
$17.95
In Stock
Exact Part matches for your search term
[Viewing 4 of 4]
HARNESS
This part number matches the current model number 10350
PartSelect #: PS1083804
Manufacturer #: 10350
No Longer Available
Mounting plate
This part number matches the current model number 10350
PartSelect #: PS12181116
Manufacturer #: 10350
No Longer Available
Return Spring
This part number matches the current model number 10350
PartSelect #: PS16242649
Manufacturer #: 10350
No Longer Available
Spool
This part number matches the current model number 10350
PartSelect #: PS18246408
Manufacturer #: 10350
No Longer Available
Common Symptoms of models starting with 10350
[Viewing 2 of 2]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
microwave oven blew fuse
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With th
... Read more
e help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix
.
.
Read less
Parts Used:
-
tad from tamarack, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
27 of 42 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
Parts Used:
-
Denice from Montgomery, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
15 of 28 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Died while heating lasagna
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers.
Parts Used:
-
connie from madison, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
9 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!