030487-0 Briggs and Stratton Generator - Overview

Fuel Line This fuel line is compatible with several different makes and models of small engine equipment and is sold as an individual part. Equipped with the securing clamp, this rubber fuel line is used to tra... Add to cart

Voltage Regulator

★★★★★

★★★★★

(3)

The OEM voltage regulator or voltage control is a part used to regulate the voltage so it can provide the right amount of power to electrical components. It attaches inside the alternator housing. The... Add to cart

Fuel Tank Valve Add to cart

E-Ring The OEM E-Ring is a silver metal part used to secure the wheel on the shaft. If broken, the wheel may fall off, and the part must be replaced. It is rated as "Easy" to install and requires pliers and a screw driver. Add to cart

Brush Holder Assembly The brush holder assembly in your generator keeps the brushes in place, allowing them to touch the rotor. It consists of a plastic brush holder and two carbon brushes with lead wires and attached spri... Add to cart

Oil Bottle Add to cart

Cover Rbc Plastic w/Cap This rear bearing cover is designed to protect and insulate the rear bearing of the engine. It is an authentic OEM replacement part with a diameter of approximately 8 inches. It comes with a center/du... Add to cart

Clip Tree Add to cart

Nut M8 Serrated Flange The manufacturer certified M8 Flange Nut is an 8mm silver, serrated, metal part. It can be installed using a wrench or socket, and is used to secure parts in place and secure the load. If broken or da... Add to cart

Briggs & Stratton 120/125V Electrical Outlet (15/20A) Add to cart

Nut, Locking Hex M8 - 1.25 Add to cart

Cap, Fuel,Vented Add to cart