Maytag Washer Dryer Combo Brackets and Flanges

Videos!

Your Price

$10.45

Maytag Washer Dryer Combo Washer Spring Outer Bracket

★★★★★

1 Review

PartSelect Number PS11743348

Manufacturer Part Number WP64067

Sold individually.

Installation Instructions

Edward from Easthampton, MA

unbalanced load...knocking sound.

Unbalanced load was creating a knocking sound (as if the clothes load was unbalanced). Dismantled the washer to find that one brackets had rusted out. [FYI: 3 bracket at 120 degree apart (for the 360 degree circle)]. I found that the hole (on the bracket) where the spring holds was gone. Purchased parts. Replaced them (spring, bracket, screw). Reassembled washer then ran wash for a cycle. Successful fix. Read more...

Videos!

Your Price

$9.95

Maytag Washer Dryer Combo Injector Sleeve Bracket - Side Mounting

★★★★★

1 Review

PartSelect Number PS11739774

Manufacturer Part Number WP22213057

This injector sleeve bracket is white and made entirely of plastic. This is a side mounting style bracket.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Richard from Ashley Falls, MA

washer was leaking onto the floor

First I disconnected the power and turned off the water supply. Then removed the front panel of the washer by removing the two phillips head screws from the lower left and right front of the machine. I then removed the four hex screws at the corners of the top of the machine using a socket set. The two screws in the front of the top come out through the inside and the two screws in the back come out through the access holes in the top. Next I disconnected the bleach/softener tube from the upper end to allow the lid to be raised. Then I swung the right hand side of the lid up fully and rested it on the left hand side support using the braces provided on the lid and resting the weight on the attached support string. The injector valve, inector nozzle and injector bracket are right on top on the left hand side. The bracket is taken out by removing one hex screw on the underside of the bracket. The valve and nozzle are removed by loosening the hex screw on the hose clamp, To replace, first assemble the rubber sleeve and plastic injector. The large end of the plastic injector should fit squarely into the slot of the rubber sleeve. To insert this assembly back into the molded end of the injector hose I used a small amout of laundry detergent to lubricate the large end of the rubber sleeve. This allowed the part to slide in without displacing the rubber sleeve from the plastic injector nozzle. Now, I replaced the associated parts (lid and front panel) and turned the water on and plugged the washer back in. No more leak. Thanks to PartSelect.com my repair was easy. I did not need to replace the injector sleeve bracket but purchased the new one in case I broke the old one during the repair. Read more...

Your Price

$27.25

Maytag Washer Dryer Combo Bracket

PartSelect Number PS11756155

Manufacturer Part Number WPW10547294

Fixes these symptoms

Noisy
See more...

Your Price

$9.95

Maytag Washer Dryer Combo Door Strike Bracket

★★★★★

1 Review

PartSelect Number PS11741072

Manufacturer Part Number WP33001793

This door strike bracket is an inch long. It is made entirely of metal and is used with male door strikes of clothes dryers.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Gay from Lutz, FL

Door Closure broken---Metal piece boken

I took the clamp out of the broken piece and inserted it into the replacement part. I put the replacement into the door and screwed it in. Read more...