MTD Snow Blower Control Cables

MTD Snow Blower Auger Cable

★★★★★

★★★★★

1 Review

This is a genuine replacement clutch cable sourced from the original equipment manufacturer, designed for use with MTD and Yard Man snowblowers. It serves as an identical replacement for a missing or damaged cable originally installed on new units and plays a vital role in engaging the auger for proper snowblower operation. Made with high-quality rubber insulation, this durable component is sold individually. Please note that the housing, trigger, and hardware are not included and must be purchased separately. For proper installation, refer to your model’s diagram, and be prepared to use tools such as pliers and a wrench set.

MTD Snow Blower Drive Clutch Cable

MTD Snow Blower Speed Selector Cable This speed selector cable is sourced from the original manufacturer and consists of a cable enclosed in an outer protective casing. It connects the control panel to the transmission/drive system of the snow blower, allowing you to adjust and select the speed at which the snow blower moves. When you adjust the speed on the control panel, the cable is activated, and it engages with the transmission to control the snowblower. The speed selector cable can fail over time due to various reasons including fraying from use and exposure to harsh conditions, corrosion, or inadequate lubrication, which causes it to become stiff. If the cable is faulty, your equipment will be unable to move, or stuck at one speed, and the control panel may be unresponsive. Disconnect the faulty cable and route the new cable through the same path. Connect the cable to the control panel and transmission, and secure it with the appropriate fasteners.

MTD Snow Blower Auger Clutch Cable

MTD Snow Blower Drive Clutch Cable

MTD Snow Blower Speed Selector Cable

MTD Snow Blower Cable Fitting

MTD Snow Blower Tiller Cable Barrel Holder

★★★★★

★★★★★

1 Review

This cable barrel holder is a genuine OEM part that is designed for use with tillers and snow throwers. Sold as an individual part, this holder measures approximately 1-inch in length and is used to secure the clutch control handle and cable together. This holder is made of durable plastic and can replace the old holder by simply removing it, inserting the cable into the new holder, and tightening it until it is locked in place.?

MTD Snow Blower Roller Cable

MTD Snow Blower Drive Cable