Kenmore Wall Oven Hinges

Videos!

Your Price

$98.18

Kenmore Wall Oven Door Hinge

★★★★★

21 Reviews

PartSelect Number PS11744215

Manufacturer Part Number WP74008014

The hinges control the rate that the oven door opens and closes, and allows the door to stay open at an angle. This hinge can be used on either the left or right hand side of your oven, and is approximately 20 1/2 inches long. If your oven door will not open or close easily, you may need to replace this part. It may be a good idea to replace both hinges at the same time. If a spring has become loose on one hinge, the other hinge is likely to have the same issue. The repair is simple and only requires a Phillips screwdriver and a small bent nail. For a full step-by-step guide, check out the video below.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

William from Statesville, NC

Oven door wouldn't close completely

Parts arrived in three days and it was an easy swap of the hinges but the same problem still existed: the oven door wouldn't close completely, so the oven light stayed on and the convection wouldn't work either unless the door closed all the way. The replacement hinge's springs apparently aren't strong enough to close it and the springs aren't adjustable - which is a design flaw. I did correct the problem though, by using three dollars worth of 1" round magnets, which I placed inside the door: they stay put and are strong enough to pull the door tight. Read more...

Your Price

$54.00

Kenmore Wall Oven HINGE

PartSelect Number PS12071031

Manufacturer Part Number 316575947

Your Price

$75.19

Kenmore Wall Oven Door Hinge - Left Side

★★★★★

1 Review

PartSelect Number PS1151518

Manufacturer Part Number 318348801

This hinge is located on left side of the oven door.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Xavier from Rocky Point, NY

Springs pooped off door hinges, causing hinges to break through door face

Remove decorative side panels on stove to expose backside of hinge and springs;
remove door;
remove old hardware;
since hinge openings were bent, straighten hinge opening in oven face;
attach spring to inside of oven;
slide hinge through opening;
attach spring to hinge;
screw hinges to oven face;
repeat on other side;
attach hinges to door;
while decorative panels are off, vacuum
install decorative panels.
DONE. Read more...

Your Price

$10.67

Kenmore Wall Oven Oven Door Hinge Pin

★★★★★

2 Reviews

PartSelect Number PS11740692

Manufacturer Part Number WP307986

This hinge pin is sold individually.

Installation Instructions

Mark from Leawood, KS

Broken Oven Door

This is an easy fix. Just before the holidays, it was imperative that this appliance be in top shape. Since the door 'hung' wrong, it was determined that the hinge pin broke. Remove the 2 phillips head screws on the door and open the door to the to a 15 degree opening. This position allows you to slip the door off the hinge levers. Now that the door is off, replace the hinge pin and slip the retainer ring on with a screw driver blade to push it on the pin. Slide the door back on the levers and fasten the retainer screws. DONE! Read more...

Your Price

$148.62

Kenmore Wall Oven Hinge Kit

★★★★★

4 Reviews

PartSelect Number PS979954

Manufacturer Part Number 5304445529

This kit comes with 2 door hinges, 2 brackets and 4 screws.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Barbara from Lagrange, IN

oven door would not stay closed tightly lost of heat

I replaced the door hinges and put a new handle on the oven door. I can not remember what was done exactly because I had a 2 and 4 yr old helping me. But I can tell you that the instructions included with the kit made the job easy. There were a few problems with the type of bit used to get the screws off (I needed a star type of bit, but used my phillips because that's what I had on hand). It worked fine, but it would have been better with the star tip screwdriver. There were helpfull hints that told me to prethread the new screws going into the oven door and frame. That was a big help instead of trying to hold the part and start the self threading screws. All in all I would order the parts again and attempt to do another repair on my oven, because it saved me a lot of money. Good luck to all the other first time repairers out there. Read more...

Your Price

$8.06

Kenmore Wall Oven DOOR BUMPER

★★★★★

1 Review

PartSelect Number PS226480

Manufacturer Part Number WB03T10156

Your Price

$58.68

Kenmore Wall Oven HINGE

PartSelect Number PS11723370

Manufacturer Part Number 316575912

Your Price

$51.25

Kenmore Wall Oven Door Hinge - Left Side

PartSelect Number PS2368687

Manufacturer Part Number 316566207

Your Price

$98.75

Kenmore Wall Oven Door Hinge Kit - Left Side

★★★★★

4 Reviews

PartSelect Number PS231474

Manufacturer Part Number WB14T10006

This hinge kit is used on the left hand side of the oven door.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Thomas from Plymouth, IN

The right hinge on my built in wall oven Broke

I took the door off, removed the four phillips screws that held the wall oven in it's hole. All the 1/4" fasteners were on the face of the over but you have to pull the oven forward to remove the hinges.
Buying thes two hinges from G.E. would have cost $ 90.00 I paid $ 55.00 from Part Select and they arrived the NEXT DAY. I did not do rush shipping. Read more...