Kenmore Refrigerator Hoses and Tubes

Popular Kenmore Refrigerator Hoses and Tubes

Your Price
$39.39
  In Stock
Kenmore Refrigerator P-Trap Drain Tube Kit
★★★★★
★★★★★
30 Reviews
PartSelect Number PS8691807
Manufacturer Part Number W10619951
The p-trap drain tube kit may also be known as the duck bill, or the drain pipe, and it is compatible with your refrigerator. The function of the p-trap drain kit is to carry the water that has formed during the defrost cycle to the bottom of the refrigerator, where your drain pan is located. The tools you will need for this repair include a 1/4-inch nut driver and a small flat-blade screwdriver. To do this repair you will need to pull the refrigerator forward in order to reach the lower access panel at the back. This kit includes the tube extension piece and spacer.
Fixes these symptoms
  • Freezer not defrosting
  • Fridge too warm
  • Frost buildup
  • See more...
Installation Instructions
Jack from DINUBA, CA
Water leaking from bottom of refrigerator onto floor
The video on website is very good and explains everything in detail. Just follow the directions. This is EASY!!!! Read more...
Your Price
$16.90
  In Stock
Kenmore Refrigerator Plastic Tube - 5/16 Inch
★★★★★
★★★★★
19 Reviews
PartSelect Number PS3536013
Manufacturer Part Number MJU62070602
This water tube, or plastic tube, is used in refrigerators and freezers. The tube ensures water is directed to parts of the refrigerator that need it, such as the water dispenser and ice maker. If you find that your current one is leaking or broken in any way, replacing the tube can fix this problem. Make sure to unplug the appliance from the power source before you start this installation project. Refer to the diagram provided by the manufacturer for further instruction and accurate guidance.
Fixes these symptoms
Installation Instructions
Debbie from FISHER, AR
Broken water line
Remove water filter and water filter holder. Removed cover on back of frig. Removed clip where water line connects to back of water filter. Took half inch wrench pushed in on water line lock to release line. Repeat at other end. Reverse steps to put on new line. Easy repair. Read more...
Your Price
$9.02
  In Stock
Kenmore Refrigerator Union Connector - 5/16 Inch to 5/16 Inch
★★★★★
★★★★★
10 Reviews
PartSelect Number PS758446
Manufacturer Part Number WR02X11330
Quick connector for plastic water line - 5/16" to 5/16"
Fixes these symptoms
  • Ice maker not making ice
  • Leaking
  • Not dispensing water
  • See more...
Installation Instructions
Marty from West Bloomfield, MI
Internal water lines brittle, cracked, leaking
First of all, the larger white plastic tubes in this thing are 5/16" OD, which no plumbing store seems to stock. At the lower left rear end there are 2 tubes, one for water and one for ice, that are doomed to fail being in proximity of a heat source - they essentially get cooked to the point of becoming brittle and cracking. The smaller tube and union can be easily found, but do yourself a favor if the larger one cracks and order the plastic tube and water tube union here, and just cut off the brittle part and amend the old tube using the union. Read more...
Your Price
$59.10
  In Stock
Kenmore Refrigerator TUBE-WATER
★★★★★
★★★★★
6 Reviews
PartSelect Number PS12745424
Manufacturer Part Number W11415785
This water fill tube is a genuine OEM part that is compatible with various models of refrigerator. It is a small plastic tube that supplies water to the ice maker tray. It is typically located at the back of the refrigerator, where it runs from the water inlet valve to the ice maker assembly. When the ice maker needs to produce ice, water flows through this tube and fills the ice maker tray, where it freezes into ice cubes. The fill tube is an essential component of the ice maker system, ensuring a steady supply of water for ice production. If the fill tube becomes clogged or damaged, it can water leaks inside the refrigerator and also lead to difficulties producing ice when needed.
Fixes these symptoms
Installation Instructions
Jenny from PHOENIX, AZ
spraying water from the connection on top of fridge
just like the video showed, removed the cover parts inside the fridge, disconnected the water tube inside and pulled out from the top of fridge, then inserted new water tube. Read more...
Your Price
$10.13
  In Stock
Kenmore Refrigerator Ice Maker Water Fill Tube Kit
★★★★★
★★★★★
25 Reviews
PartSelect Number PS11739222
Manufacturer Part Number WP2196157
The icemaker water fill tube provides water to the icemaker so it can produce ice and dispense water. If you notice that your ice maker is not making or dispensing ice, or is leaking, you may need to replace the water fill tube. This water fill tube kit comes with a fill tube and a compression nut. This part is made of white plastic and is approximately 10 inches in length. The ice maker water fill tube is in the rear of the fridge. To complete this repair, you will need a 1/4 inch nut driver and a utility knife. Before beginning this repair, you may want to disconnect the water and power supply to the refrigerator.
Fixes these symptoms
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • Leaking
  • See more...
Installation Instructions
Charles from Orland Hills, IL
Broken elbow on icemaker water fill tube.
Removed 2 screws holding water fill tube to rear of refrigerator and pulled out, matched old part with new to make sure of proper match. Guide new fill tube thru hole, making sure it is aligned with slot in ice cube tray on inside of freezer. Install new plastic line from water pump outlet to water fill tube, check for leaks, job done. Read more...
Your Price
$46.75
  In Stock
Kenmore Refrigerator Filter Inlet Water Tube
★★★★★
★★★★★
17 Reviews
PartSelect Number PS886401
Manufacturer Part Number 8201597
As per the manufacturer, this part starts out as 1/4" tubing but ends up at 5/16".
Fixes these symptoms
Installation Instructions
George from Hernando, MS
Pur Water filter ruptured could not remove from housing
Removed two screws holding the filter housing. Pulled filter and housing out far enough to remove inlet and outlet lines.Replaced inlet and outlet lines( precautionary) in filter housing, installed new filter. Read more...
Your Price
$36.02
  In Stock
Kenmore Refrigerator Water Tube Kit
★★★★★
★★★★★
7 Reviews
PartSelect Number PS11730901
Manufacturer Part Number W10823511
This is the replacement water tube kit for your refrigerator. This tubing is made of plastic, is 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube, and may need to be cut. This water tube transports water to the ice and water dispensers. If your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
  • Ice maker not making ice
  • Leaking
  • Not dispensing water
  • See more...
Installation Instructions
Trent from Tacoma, WA
water dispenser started leaking
i wasn't sure it was the inlet valve unit because the leak was at the water dispenser in the freezer door. after some research it looked like the water inlet valve located in the back lower part of the refrigerator was the problem. to replace, take off the cardboard cover, about 6 screws, you have access to the water inlet valve, disconnect the hoses (i think it goes without saying that you should have turned off the water to the frig) replace the inlet valve, connect hoses, turn water back on and you'll be back in business. very easy repair. Read more...
Your Price
$25.02
  In Stock
Kenmore Refrigerator Grommet / Tube Assembly
★★★★★
★★★★★
5 Reviews
PartSelect Number PS292253
Manufacturer Part Number WR17X11168
This is a replacement fill tube and grommet assembly for your refrigerator. This part acts your water line to your ice maker. If you’re noticing water in the back of the refrigerator or any kind of leak, or if your ice bucket isn’t filling up with as much ice, you may need to change out the fill tube and grommet assembly. When you purchase this part, you get the water line, as well as the fill tube and grommet. This is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
  • Ice maker not making ice
  • Leaking
  • Not dispensing water
  • See more...
Installation Instructions
Chuck from Coraopolis, PA
Water leaking under the refrigerator only when water was called from water dispenser
To do this repair, I shut off the water supply first. After removing the back panel, I disconnected the first water tank (PS291933) tube from the valve near the back of the refrigerator by pushing the white ringclamp towards the valve which released the tubing (once disconnected I could clearly see the hairline crack in the tube responsible for the water). I then disconnected the other water tank tube from the connector located in the bottom left front of the refrigerator. Then, after removing the bottom shelves and compartments, I unscrewed the two screws securing the water tank to the inside back wall. Then I carefully pulled the water tank and the tubing out from inside the refrigerator. The installation of the new water tank was essentially the reverse of the above, with the exception that I had to use a 2x4 to prop up the refrigerator and my 7-year old daughter's hand to help guide the tube to the front of the fridge. One of the lines did leak initially, but stopped after I removed and reconnected the tube more securely. My only unfinished business with this part of the repair (which I'm not losing sleep over) is I'm not sure where to find the 'insulation wrap' that was around the water tank tubes inside the fridge.

During my investigation of the water tank, I also noticed the tube on the outside back of the fridge going to the icemaker was leaking, so I bought a new grommet & tube (PS292253). Installation was easier than the water tank, but was more of a mystery until the part showed up and I saw that only adhesive tape was used to secure the grommet to the hole in the outside back of the freezer near the icemaker. Again, only had to disconnect the tube from the valve at the bottom of the fridge and pull out the grommet from the top outside. (I did remove the ice cube tray from the inside to avoid contaminating it during the work). Then I connected the new tubing and secured the grommet to the back of the fridge using the adhesive tape. So far no leaks!


I also will likely need to add that WR49X10173 part to hopefully avoid my water dispensor from freezing in the future.
Read more...
Your Price
$9.34
  In Stock
Kenmore Refrigerator Holder,Pipe
PartSelect Number PS3535430
Manufacturer Part Number MEG61879201
Fixes these symptoms
Your Price
$27.99
  In Stock
Kenmore Refrigerator Tube Assembly,Ice Water
★★★★★
★★★★★
3 Reviews
PartSelect Number PS3533046
Manufacturer Part Number AJR56656503
Fixes these symptoms

Related Kenmore Refrigerator Parts