Husqvarna Leaf Blower / Vacuum Carburetors

Your Price

$9.93

Husqvarna Leaf Blower / Vacuum Chainsaw Purge Bulb

PartSelect Number PS9471212

Manufacturer Part Number 530047721

This primer bulb, also known as a purge bulb, is used to push more fuel from the fuel tank into the carburetor of your small engine equipment, to help the engine start easier. Over time and through extended use and exposure to gas and oil, the bulb of the primer will eventually lose its elasticity and crack or break. This bulb is made of plastic and can be replaced by accessing the ignition system. Disconnect the fuel lines and pop out the bulb with a set of pliers, and once you pop in the new bulb, you just reconnect the fuel lines. This bulb is compatible with a variety of makes and models of small engine equipment and is sold as an individual part.

Installation Instructions

Robert from MANVILLE, NJ

Replace the fuel lines

Replaced all fuel lines. Followed instructions found on Partselect.com, which said to insert cut fuel line in tank and use forceps to reach back in the tank and pull the fuel line through. The problem was that I did not have forceps, or needle nosed pliers that could reach the end of the hose.

Instead of running the line into the tank, I found another suggestion online to run the line from inside the tank outward, allowing me to grab the line with any pliers and thread it. The way I did this was used about a foot length of 14 gauge copper wire. Put an inch or two into the hose (that has been cut on an angle), and use a little black tape to secure the hose on the wire. Now you should be able to route the stiff wire from inside the tank to the fuel hole in the tank. Fish the wire through, and it should be enough to get the tapered end through the tank. Pull the copper wire, mine came out, but there was enough of the hose exposed on the outside of the tank for me to grab with pliers and pull it through. Read more...

Your Price

$41.09

Husqvarna Leaf Blower / Vacuum Carburetor Kit

PartSelect Number PS16379328

Manufacturer Part Number 590460102

Your Price

$22.40

Husqvarna Leaf Blower / Vacuum Chainsaw Gasket And Diaphragm Kit

★★★★★

1 Review

PartSelect Number PS9472427

Manufacturer Part Number 530069844

This is a genuine manufacturer-sourced replacement gasket repair kit that is specially made for use with Paramount and Poulan lawn and garden equipment. It is utilized to replace carburetor gaskets and diaphragms that were originally installed on a new unit. If you have a problem with your carburetor this will usually take care of it. Keep in mind this high-quality kit is sold individually. Please make sure to refer to the appropriate diagrams of your model for the exact locations and applications of these components.

Your Price

$56.05

Husqvarna Leaf Blower / Vacuum Trimmer Metering Diaphragm

PartSelect Number PS11811115

Manufacturer Part Number 503896701

Your Price

$8.71

Husqvarna Leaf Blower / Vacuum Leaf Blower Carburetor Plate

PartSelect Number PS9029413

Manufacturer Part Number 545133301

Your Price

$34.85

Husqvarna Leaf Blower / Vacuum Trimmer Fuel Pump Diaphragm

PartSelect Number PS11811118

Manufacturer Part Number 504130807

This fuel pump diaphragm, also called a membrane or a gasket, is what helps pump fuel from the tank to the engine of your gas-powered lawn equipment. It is normally found attached to the carburetor assembly itself. You can tell that the diaphragm is broken when your engine is not starting properly, lacks power, or frequently stalls. You may also notice that your machine is leaking fuel or smells strongly of gasoline. A broken diaphragm could lead to engine performance problems, and it may eventually stop working altogether. When replacing your old diaphragm, you will need a wrench to disconnect it from the fuel pump housing. Kindly note that this OEM-sourced component is sold individually.