Gibson Dishwasher Springs and Shock Absorbers

Videos!

Your Price

$45.95

Gibson Dishwasher Door Spring

★★★★★

12 Reviews

PartSelect Number PS815938

Manufacturer Part Number 154430501

This door spring is manufactured for a dishwasher door. The door spring applies tension to the dishwasher door so that the door does not drop too quickly when it is opening. If the door drops too quickly, it could cause damage to the dishwasher door or dishwasher door hinges. This spring is sold individually. Check the spring on the opposite side of the dishwasher door, they often wear at the same rate so you may want to replace both springs for exact tension on either side. No tools are required for this repair. This is an OEM replacement part.

Fixes these symptoms

Door latch failure
Door won’t close
See more...

Installation Instructions

Daniel from Fremont, NE

Dishwasher door practically fell open

All I had to do was replace the spring and retainer on the side of the dishwasher which amounted to pulling it out far enough to reach the eyelet that the hook went into and then stretching it to the retainer attached on the other end. I really like partselect, I have done some things in the past and they are very helpful on the site and on the phone and I would recommend them to anyone and I would not normally do that unless it has been an excellent experience. Read more...

Your Price

$43.95

Gibson Dishwasher Single Door Spring

★★★★★

3 Reviews

PartSelect Number PS452475

Manufacturer Part Number 5300809703

NOTE: Sold individually. This door spring is four and a half inches long. It is used for some dishwashers. These springs tend to wear out at the same rate, so you should replace both of your dishwasher door springs at the same time.

Fixes these symptoms

Door latch failure
See more...

Installation Instructions

Randy from Orlando, FL

Bad door gasket-leaking, broken door spring

My door spring had broken and I was going to leave it until the door gasket failed and started leaking. After removing the parts, I got on-line and order what I needed. I found everything easier than I thought. I got the parts a few days later and put the gasket in first. Looking at it, you'll find theres slotted ribs at both ends. Those areas go in the bottom corners because of the "S" curve. Simply push in and voila, you're done. At first the door will be firm to shut, but gets better- NO LEAKS! As far as the door spring...you don't have to remove the whole dishwasher. Simply unscrew the bottom plate under the door and reach in, rehook. Piece of cake. This site is wonderful. All the parts and easy to use. Read more...