General Electric Ice Maker Hardware

Your Price

$7.95

General Electric Ice Maker Refrigerator Single Hex Head Screw

PartSelect Number PS11742731

Manufacturer Part Number WP489069

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Installation Instructions

Chris from Pompano Beach, FL

Water in bottom of dishwasher

Disconnected power. Shut off water supply. Took off the front, disconnected copper supply line and flexible water line, removed water inlet valve. Took elbow from old inlet valve and put in on new one. Put new valve in, reconnected water lines, put back front panel. Opened water supply, Flipped breaker back on. Done and it worked! Read more...

Your Price

$16.95

General Electric Ice Maker Scoop

★★★★★

4 Reviews

PartSelect Number PS12745542

Manufacturer Part Number W11420408

This ice maker scoop is an OEM refrigerator part designed to retrieve ice from the ice maker bin. It is made of plastic and measures approximately 10 3/4 inches in length and 4 inches in width. The scoop is designed to fit inside the ice bin for easy access. You will need to replace the scoop if it is cracked, broken, or lost. Discard the old scoop and insert the new one into its designated compartment.

Your Price

$9.95

General Electric Ice Maker Refrigerator Screw

★★★★★

1 Review

PartSelect Number PS11745622

Manufacturer Part Number WP8281196

Sold individually.

Installation Instructions

Carol from Monroe, NY

Refrig making a lot of noise

The motor kit had only two wires coming out of it. The existing one in the refrig had 6. I spliced the 2 red to one black on the new part and 2 white to the other black wire on the new part. The two green I attached to a screw. I left the 6 wire harness in place just cut off the plug piece that went into the old motor, and spliced all my wires.
Worked great! Read more...

Your Price

$11.95

General Electric Ice Maker Refrigerator Screw

PartSelect Number PS11742748

Manufacturer Part Number WP489442

Sold individually.

Your Price

$7.95

General Electric Ice Maker Screw

PartSelect Number PS11742749

Manufacturer Part Number WP489443

This screw is sold individually.

Your Price

$9.95

General Electric Ice Maker Washer Push-in Nut

PartSelect Number PS11743768

Manufacturer Part Number WP692400

Installation Instructions

tselanea from elkton, MD

dryer was not putting out heat

i removed the heater element and put a new one in. Read more...

Your Price

$9.95

General Electric Ice Maker Grommet

PartSelect Number PS11731224

Manufacturer Part Number W10852725

Your Price

$11.95

General Electric Ice Maker Washer Clamp

PartSelect Number PS11742760

Manufacturer Part Number WP489503

This clamp is sold individually.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Gregory from Louisville, KY

leaking water under back left of washer

The first thing I did was look at the diagrams for my specific appliance on the parts select web site to locate fastners. I removed the front panel(2 screws 4" from floor on front panel), then removed the corner bolts of top panel(found under in front). Next I removed the 4 screws on the control panel (on top). I located the screw holdling the fill injector to the top Lid. Then I removed the clamp holding the unit to the regulator. Assembled the unit and placed it in position. First attaching the fill injector to top panel, then clamping the hose to regulator, then replacing 4 screws in control panel. Next the two corner screws in corners under the top panel. Replaced front panel and 2 screws. Then had a trail run and no water leaks any where. Read more...