Craftsman Edger Control Cables

Your Price

$11.12

PartSelect Number PS11985186

Manufacturer Part Number 753-06546

This throttle cable is responsible for controlling the engine speed in edgers. It is a manufacturer-approved cable designed with specific end fittings that connect to the throttle control lever on one end and the carburetor on the other. When the throttle control lever is adjusted, the cable transmits the motion to the carburetor, which allows the user to regulate the engine speed. Over time, the throttle cable can wear out, fray, or become disconnected, leading to loss of throttle control, lower power output, and engine stalling. To replace the throttle cable, first ensure the engine is off and cool, for your safety. Locate the end fittings on the cable and disconnect them carefully. Remove the fasteners that secure the cable, and then route the new cable along the same path as the old one. Finally, reconnect the end fittings, and adjust the cable tension as necessary.

Your Price

$20.38

Craftsman Edger Wheel Adjust Cable

PartSelect Number PS9179266

Manufacturer Part Number 946-04036

This wheel adjustment cable is used for both lawn edgers and trimmers and measures 32.75-inches in length. Featuring a metal cable insulated with rubber, this cable is used to raise or lower the blade within your equipment to control the cutting depth and is connected to a lever near the handle. Depending on your model, the installation instructions may vary, so check your user manual or any relevant diagrams for assistance.