Enter the code USA15 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on July 4 at 11:59pm EST.
Amana Washer Dryer Combo Parts
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Amana Washer Dryer Combo Parts
- Marks left on clothes
- Noisy
- See more...
2. pop off top of unit
3. remove front of dryer
4. lay unit on its back
5. remove drum and replace pulley assembly,belt,drum rollers of which it has 2 rear and 2 front
6. reverse above and then remove filter-vent housing and scrape off old seal install new seal
7. re-connect power,gas and vent use again
8. only sad part to whole job was seeing how cheaply whirlpool now makes thier products Read more...
- Drum Not Spinning
- Noisy
- Won’t Start
- See more...
- Drum Not Spinning
- Noisy
- See more...
- Burning smell
- Leaking
- Noisy
- See more...
First take off the water pump by removing the two clips that hold it in place. Place a shallow pan under the pump to catch the water that is in the pump and hoses. Open the hose clamps with a pair of pliers or channel locks (better) and slide the hoses off of the water pump.
The motor comes off next. Unplug the electrical connector from the motor and two wires from the capacitor. Remove the two screws holding the clamps in place and then pop off the two clamps. You will need to hold up the motor with one hand while you remove the clamps or it will fall to the floor once the clamps are removed.
One piece of the coupling assemble will be attached to the motor and the other will be attached to the gearcase drive shaft. If you want to clean up the mess created by the shredded rubber center piece of the coupling assembly you will have to take off the motor mounting plate. It is held on by two bolts and removing it makes installing the coupling easier but probably not necessary.
Push the back half of the coupling on to the gearcase drive shaft until the shaft is flush with the face of the coupling. Install the new rubber center piece on to the coupling then re-install the motor mounting plate. Install the other half of the coupling on to the motor shaft and lift the motor up to the coupling. You have to rotate the motor shaft by spinning the fan blades until the coupling lines up so you can slide it into the other half of the coupling. Then just reattach the motor, connectors and water pump in the reverse order of disassembly. Read more...
- Burning smell
- Spinning Issues
- Spins slowly
- See more...
- Leaking
- Shaking and Moving
- Spinning Issues
- See more...
- Not Heating
- See more...
- Marks left on clothes
- Noisy
- See more...
- Marks left on clothes
- See more...
- Noisy
- See more...
Amana Washer Dryer Combo Appliance Types
Related Amana Washer Dryer Combo Parts
- Amana Washer Dryer Combo Hardware
- Amana Washer Dryer Combo Springs and Shock Absorbers
- Amana Washer Dryer Combo Seals and Gaskets
- Amana Washer Dryer Combo Wire Plugs and Connectors
- Amana Washer Dryer Combo Brackets and Flanges
Popular Amana Washer Dryer Combo Models
Below are the most popular Amana Washer Dryer Combo models we have. Enter your model number in the search box to find your model.