Pressure Washer Filters
Popular Pressure Washer Filters
Pressure Washer Filter- A/C Cartridge
PartSelect Number PS8987387
Manufacturer Part Number 491588S
This is a replacement air filter/AC cartridge for your small engine. The air filter prevents dirt and debris from entering the engine. Over time, the air filter can become clogged or damaged, and this can lead to reduced performance. This air filter is approximately 4 inches wide and approximately 5 inches long. To replace the air filter, locate the air filter cover on the side of the engine, unscrew it, and remove the old filter. Be sure to clear out any dirt, clippings, or other debris that has found its way into the air filter assembly before you insert the new filter. Reattach the air filter cover, and secure it with the screws. This product is sold individually.
Fixes these symptoms
- Will Not Start
- See more...
Installation Instructions
Barry from FRANKFORT, KY
replaced gasket that go's between the air cleaner housing and carb. cleaned housing and reinstalled with new air filter
Also replaced fuel tank , the built in fuel shut off started leaking , had to replace the tank. Ordered a new one Briggs & Stratton original equipment fit perfect . This is a 25 year old Briggs & Stratton lawn mower 3.5 HP, Runs perfect, starts by the 2nd crank every time. First time I ever had to spend money on it since I bought it new in 1991
Read more...
Pressure Washer Filter-A/C Foam
PartSelect Number PS8983404
Manufacturer Part Number 493537S
Installation Instructions
Morris from HOPE MILLS, NC
Mower was submerged in Hurricane Matthew
Total disassemble, clean out water and any rust. hone cylinder, wire brush where needed,reassemble with new rings,gaskets and seals and lucas oil product. Started on second pull. Mowed lawn. If you have never done this sort of work before, probably should not attempt.
Read more...
Pressure Washer Fuel Tank Outlet Assembly
PartSelect Number PS9873293
Manufacturer Part Number 099980425080
Installation Instructions
Jimmy from BURLINGTON, NC
Fuel system damaged by allowing E85 gas to remain in tank.
Tank is held in place by 2 nuts and 1 bolt. These were removed and tank lifts off. Installed filter assembly and fuel hose to bottom of new fuel tank. You must install fuel hose clamp to tank connection before installing new tank. Install the other end of fuel line to carburetor on engine with other clamp and you are finished.
Read more...