Enter the code USA15 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on July 4 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
This dishwasher door hinge cable assembly connects the door to the spring. The door hinge cable and the door spring apply tension to the door to prevent it from dropping open too quickly. This part co...
The dishwasher roller assembly connects to the dishrack, and is located in the lower level of the dishwasher. It allows the dishrack to easily slide in and out. If the lower rack keeps falling off the...
The rack roller and axle in your dishwasher allows the dish rack to slide in and out effectively.If you notice that your dish rack is not performing this function, or if one or more of your rack rolle...
The door spring, used in dishwashers, adds tension to the door through the door hinge to keep it from opening too fast. If you have a door latch failure or your washer door drops too quickly when open...
On a washer, this part is used for circulating the water. On a dishwasher, it is used for draining the water during operation. If you notice your appliance is not draining properly, the circulation pu...
This is a door gasket for a dishwasher. It creates a watertight seal between the dishwasher door and tub to prevent leaking while the appliance is in use. The gasket is approximately 76 inches long an...
This is a pump gasket, also known as a pump housing seal, for a dishwasher. The gasket is fitted around the edge of the pump, preventing leakage between the pump housing and the filter housing. Locate...
This is an accessory assembly, otherwise known as a mounting bracket kit, for a dishwasher. This kit includes two brackets, a hose clamp, and two screws. The brackets are perforated so they can be cut...
Replacement dishwasher drain hose. Per the manufacturer if the drain hose being replaced does not have the vent tube going to the water inlet assembly a new water inlet will be needed.
This diverter motor, or stepper motor, controls the movement of the spray arms in your dishwasher. It directs water between the drain pump and the spray arms by turning a check valve inside the pump, ...
This circulation pump filter in your dishwasher traps food and debris, preventing them from entering the wash cycle again. It is often located at the bottom of the dishwasher. If this filter is broken...
$87.43
In Stock
Questions And Answers for LDF6920ST
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kent
January 16, 2020
Try to run a load of dishes had run some the night before no problems when i tried to power it up to set it to wash nothing happened. When i jiggled the door something made power come on maybe a loose wire. I start running it a few minutes later it shut down and this time it wouldn’t power back up. When i jiggle the door again thought i saw a little spark at the bottom so i unplugged it and left it.
For model number LDF6920ST
Hi Kent, thank you for your question. It sounds like you may need to replace the door latch/lock: PS3522841. That part will not allow your power to come on if it believes that the door is open in any way. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Paul
January 26, 2020
Just got the error code le while dishwasher was running. Shut off the breaker and restarted the cycle and got the same code. Error code said its either the wiring harness or the motor. It's been much noisier recently so i'm guessing its the motor. Is there any way to tell which it is for sure? Tried to see what a motor would cost and found multiple motors listed. What motor does this code refer to?
For model number LDF6920ST
Hello and thank you for writing.
The LE error code on the LG dishwasher display is an indication of a MOTOR ERROR. The 5 issues that may cause this fault code is a wiring problem (the most common reason for LE error), the impeller of the washing pump is locked, the rotor of the washing motor is locked, the blade is locked, or the PCB main control board is faulty. According to our database, the model number you provided is just a portion of a model number with multiple possible variations. To ensure that we recommend parts that will work for your model, please check your information again; you will need to provide us with the full model and serial numbers located on the sticker on the unit itself.
Once we have that information, we would be happy to find the part you need. We are looking forward to your reply, please always notate the model number. Thank you.
Was this helpful?
Thank you for voting!
Ed
April 27, 2023
My door just stopped closing. The latch isn’t working.
For model number LDF6920ST
Hi Ed, thank you for reaching out. The issue is probably due to the door hinge cable assembly, part number PS3524406. We hope this helps!
Dishwasher makes growling sound during the whole cycle, but still cleans dishes. What do you feel is the problem and what part do I need?
For model number LDF6920ST
Hi Mark, thank you for reaching out. Based on the description, we have concluded that the issue is with the sump assembly, part number PS3532844. We would recommend replacing the sump assembly to fix the issue. Glad to be of assistance!
Simple, removed screws securing machine in the cabinet, then pull the unit out of the cabinet space about 10 inches. Springs are accessible within this extension. You need strong hands to extend the springs and attach them. Once attached, push machine back in place and re-install the anchor screws. In my situation, only one spring was bro
... Read moreken, so the attached side revealed the correct slot to place the hook on the top position, the bottom position has a plastic lead for the spring, and that lead is attached to a rope to the door hinge. Note: Replace BOTH springs, even if only one is broken.
Pull the dishwasher out from underneath the countertop took 2 minutes unscrewed the panel on the side one minute put the connector on one minute screwed the panel back on 1 minute put the dishwasher back underneath the counter two minutes very easy job