General Electric Wall Oven Hardware

Videos!

Your Price

$16.66

General Electric Wall Oven Single Heating Element Support Clip

★★★★★

7 Reviews

PartSelect Number PS243701

Manufacturer Part Number WB2X9719

The metallic clip, or also known as a broil element support, is for a oven element on a range. This part holds the broil element in place on top of the oven. If your support clip is broken then this replacement should be the solution. The tools needed for this project are slip joint pliers. For safety precautions, make sure to unplug your range from the power source, or shut off the house circuit breaker before starting this project. Refer to the installation instructions for best results and accuracy.

Fixes these symptoms

Element will not heat
See more...

Installation Instructions

Paul from Canton, NY

broiling element had burned through, req. its replacement

First I removed the two screws that hold the element in place. I also removed a screw that held one end of a support bracket. I then pulled the element out about 3 inches and disconnected the two wires. Reversing these steps, I finished the element's replacement.

I had noticed that the former element was sagging at the front end. I installed the additional clips (not original) on each forward end of the element for additional support. Read more...

Your Price

$13.77

General Electric Wall Oven Mounting Screw

★★★★★

1 Review

PartSelect Number PS6011723

Manufacturer Part Number WR01X11014

This OEM part is from GE and is designed for use in your refrigerator. This part is known as a door mounting screw, and is for mounting the handles of the refrigerator to the door studs.

Fixes these symptoms

Door won’t open or close
See more...

Your Price

$8.06

General Electric Wall Oven SET SCREW

★★★★★

1 Review

PartSelect Number PS8767906

Manufacturer Part Number WR01X20424

Installation Instructions

Charles A. from ARVADA, CO

Missing parts bought new

Very well with a print out and Allen wrench was easy Read more...

Your Price

$9.63

General Electric Wall Oven Ignitor Mounting Screw

★★★★★

2 Reviews

PartSelect Number PS234519

Manufacturer Part Number WB1X1293

Sold Individually.

Fixes these symptoms

Little to no heat when baking
See more...

Installation Instructions

CHRISTOPHER from REDMOND, OR

Oven Igniter Died

The only difficult part of the repair was getting the original screws out of the old igniter and oven gas arm. Once I drilled the old screws out the repair was done within 20 minutes. Read more...

Your Price

$12.19

General Electric Wall Oven SCREW 10-32 TR T

★★★★★

2 Reviews

PartSelect Number PS222157

Manufacturer Part Number WB01T10008

This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to connect the different parts of your oven door. This part is an authentic OEM part sourced directly from the manufacturer.

Your Price

$8.06

General Electric Wall Oven STUD COMPOSITE

★★★★★

2 Reviews

PartSelect Number PS2353323

Manufacturer Part Number WB02T10453

Your Price

$10.80

General Electric Wall Oven SPACER REINFORCEMENT

PartSelect Number PS2353322

Manufacturer Part Number WB02T10452

Your Price

$8.77

General Electric Wall Oven Screw

★★★★★

1 Review

PartSelect Number PS234226

Manufacturer Part Number WB1K5157

This screw is black in color and sold individually.

Your Price

$8.30

General Electric Wall Oven Screw

★★★★★

2 Reviews

PartSelect Number PS234427

Manufacturer Part Number WB1X1130

Sold Individually.

Installation Instructions

George from MILWAUKIE, OR

GE WB44T10086 Range Convection Element AP4358533 PS2321875 interrupted

after you disconnect the direct breakers and open the oven:
1. remove the first 4 screws and the fan's cover
2. remove the short screws from element convection assembly
3. gently pool both wires and disconnect the old element (two terminals)
4. carefully insert the terminals in the new element.
5. re-screw the short 4 screws (better to buy new ones with the assembly) They are available but sold separated.
6. fix back the fan cover,
re-connect the breakers and that's it! Read more...