Frigidaire Wall Oven Circuit Boards and Touch Pads

Your Price

$42.45

Frigidaire Wall Oven Overlay - Black

PartSelect Number PS2581771

Manufacturer Part Number 316419141

This is the overly only. Control board is NOT included. Black in color. Genuine OEM part.

Fixes these symptoms

Touchpad does not respond
See more...

Installation Instructions

Robert from Slidell, LA

Bake element blew out

Removed and replaced bake element. Discovered that oven control module had also blown out. Ordered and replaced new control unit. Stove placed back in service. Read more...

Your Price

$29.14

Frigidaire Wall Oven Overlay - White

★★★★★

1 Review

PartSelect Number PS2581767

Manufacturer Part Number 316419137

Installation Instructions

David from PALATKA, FL

Had a F1 code on the range, could not control the bake temp.

Replace the electronic control board & overlay. Tested, works great! Read more...

Your Price

$74.62

Frigidaire Wall Oven Oven Clock Overlay - Black

PartSelect Number PS439807

Manufacturer Part Number 316220805

This part goes in front of the clock/timer to allow visual indication of where the buttons are on the oven. Example bake, broil & clean.

Installation Instructions

CAROLE from ALCALDE, NM

Handy ?? :-)

Just plugged in new electronic clock/timer after putting oven clock overlay on front of part. The only sad part was if didn't work could not return as you consider used. Bad business as if not installed how will you know if it works? Would be out $400.00 + Read more...

Your Price

$337.52

Frigidaire Wall Oven CONTROLLER

PartSelect Number PS11731809

Manufacturer Part Number 5304503761

Your Price

$275.68

Frigidaire Wall Oven Dual Element Control with Potentiometer

PartSelect Number PS1149760

Manufacturer Part Number 316441804

Installation Instructions

Michael from Boynton Beach, FL

Broken left front dual-element potentiometer (switch)

1. Cut Power
2. Remove knobs
3. Remove 4 large hex nut with 1-1/8" socket
4. Rotate panel on to stove top (place a towel first) . Watch for top seal (at the top of the panel). This needs to be put back in place (easy).
5. Remove nut on switch holding the module (my was broken)
5. Remove 6 inner panel screws (philips)
6 Guide broke switch module clear of inner panel
7. Swap wires and connectors.
8. Place new module into postion tighten nut while supporting module (hand tight then another flat. I used a socket so the switch stem could protrude, and a pair of channel locks)
9. Re-assemble, making sure to position the top seal correctly.
10. Power-up & check out.

The apppliance store wanted over $150 to install it. But I could do it myself.

Some confusion on which part to order as the diagrams for the potentiometers show 3/1 configuration and indicated the front right potentiometer being different. My unit has 2/2 configuration (Front 2 large, Back 2 small) all dual-element. The diagram points to the front left as being different.

Even the local appliance store wasn't sure which to order and had to send a fax to find out (which came back talking about a 3/1 configuration).

I ordered the right front because I assumed it was for the higher wattage. I got the box and it was stamped "left front". Double check the boards and both looked identical

The whole process went smooth, part came in a couple of days after ordering. Read more...