Frigidaire Dishwasher Seals and Gaskets
Popular Frigidaire Dishwasher Seals and Gaskets
Your Price
$21.06
In Stock
Frigidaire Dishwasher Bottom Door Gasket
PartSelect Number PS9495545
Manufacturer Part Number 809006501
This dishwasher door gasket (Bottom Gasket, Gasket, Door Seal, Dishwasher Door Lower Seal) helps prevent water from leaking out of the bottom edge of your dishwasher door by creating a watertight seal. This part is attached to the bottom of your dishwasher inner door panel. It is frequently exposed to water and detergent during its lifetime. The water and chemicals can eventually wear down the gasket and compromise the integrity of the seal. If the gasket is malfunctioning, the integrity of the door seal will be effected. You will notice leaking through the bottom of your dishwasher door. If your dishwasher is leaking water from the bottom of the door, first inspect the seal for food particles near the bottom and sides, and remove the buildup, as it can stop the door from closing properly and keeping a tight seal; if not, you may need to replace the bottom door gasket. Check the door gasket for tears, cuts, or wear. This part is sold individually and measures 22.5 inches by 1.25 inches. It is constructed of plastic, and comes in yellow/grey. Includes one lower door gasket.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Scott from Flowood, MS
Bottom Door Seal fell apart and started leaking.
First I opened the door all the way. Second I reached down to the bottom gasket then grabed it on the right end of the seal that is on the right side of the door. Then I pulled the end outward from the bottom of the door toward the heater coil in the bottom of the washer. It came out real easy. You see it just snaps into a little plastic groove under the door. I then cleaned up the area for food and soap particules. I then placed the new gasket in place by lining up the notch toward the right end with the piece of plastic that encloses the right end of the plastic notch on the bottom right end of the door. Then push it in untill it stops going into the notch. It snaps in but does not make a snaping sound. It just won't go in no more.
Read more...
37% OFF
Your Price
$20.45
$32.35
In Stock
Frigidaire Dishwasher Tub Gasket - Gray
PartSelect Number PS8260227
Manufacturer Part Number 154827601
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing water leaking out. If broken, it should be replaced. Refer to your model number and user manual to ensure this part is right for you. When making this repair, open the dishwasher door and take out the lower dish tray for better access. Pull out the old gasket, and clean the channel with a rag. Push the new gasket into place into the notch on the door, which you should see upon close inspection, using a flat-head screwdriver for assistance if necessary. We do not recommend cutting any additional length off on the tub gasket if any is present during your repair.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Charles from Milton, FL
dishwasher was leaking water
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
Read more...
Frigidaire Dishwasher Door Bottom Seal
PartSelect Number PS11703834
Manufacturer Part Number 5304500204
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and leave the door closed for several hours to properly seat the new door seal.
Fixes these symptoms
- Leaking
- See more...
Installation Instructions
Richard from CASTLE ROCK, CO
Dishwasher leaking at the bottom of door
The door seal comes off easy. No need to take apart the door. The new seal fits snug. Make sure the notch on the right side of the door seal is installed to the right side of the bottom of door
Read more...
65% OFF
Your Price
$13.67
$39.42
In Stock
Frigidaire Dishwasher Splash Shield Kit
PartSelect Number PS2203346
Manufacturer Part Number 154701001
This splash shield kit is used in dishwashers and is attached to the lower front corners of the tub. The splash shield is used to prevent water from spraying past the door seal. If your dishwasher is leaking from the corners of the door gasket, replace this part. For this repair, the only tool needed is a flathead screwdriver. The measurements of this part are: 1.50 inches in length, 0.50 inches in width, 1.70 inches in height. It weighs 0.10 pounds. Remember to unplug your appliance from the power source as a safety precaution.
Fixes these symptoms
- Leaking
- See more...
Installation Instructions
Sandra from DAYVILLE, CT
Leaky on bottom right
Pulled out old gasket and shield guards and put in new ones. No tools needed. Piece of cake??
Read more...
Your Price
$63.70
In Stock
Frigidaire Dishwasher Door Latch and Gasket
PartSelect Number PS979852
Manufacturer Part Number 5304442175
Black in color. No longer available in almond.
This door latch prohibits the dishwasher from operating when the door is open. The gasket is used around the door to keep the dishwasher from leaking.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Richard from Princeton, NC
plastic handle broke
First I removed and replaced the gasket around the tub. It didn't require any tools and took about 2 minutes to complete. I didn't really need to replace the gasket but it came with the latch kit so I went ahead and replaced it anyway. Than I removed only the top door panel (6 screws) and supported it while I removed the broken latch (2 Torx screws). I had to use a pair of needle nose pliers to pull the wires off the old latch (keeping track of where each wire came from) then plugged the wires onto the new latch and screwed it back to the door. Put the door panel back in place with the 6 screws I had removed earlier and I was done. it all took about 15 minutes and the wife is so glade she is not doing dishes by hand anymore that she left me alone for the rest of the night.
Read more...
Your Price
$10.60
In Stock
Frigidaire Dishwasher Delivery Tube Gasket
PartSelect Number PS421211
Manufacturer Part Number 154406401
Sold individually.
Fixes these symptoms
- Leaking
- Not cleaning dishes properly
- See more...
Installation Instructions
Mary from Alexandria, VA
Upper spray arm had been "blowing off" during wash cycle.
Unscrewed retaining ring, replaced unit = piece of cake
Read more...
Your Price
$86.32
On Order
Frigidaire Dishwasher GASKET
PartSelect Number PS2379444
Manufacturer Part Number 5304475599
Fixes these symptoms
- Leaking
- See more...
Frigidaire Dishwasher High Temperature Adhesive
PartSelect Number PS474458
Manufacturer Part Number 5308027429
This high temperature adhesive is used for installing felt and rubber seals on dryers. The tube contains 1 ounce of product. This adhesive is made to withstand extremely hot temperatures. Before applying the adhesive, ensure that the area is completely clean from any debris and is dry. You may wish to use small clamps to hold the material in place while it dries. If the felt has come loose or broken apart, this may cause your dryer to make loud noise, indicating that new felt or rubber needs to be glued into place. Use gloves to apply glue.
Fixes these symptoms
- Marks left on clothes
- Noisy
- See more...
Installation Instructions
Gerald from Alliance, NE
Burned out heater element
1.Remove 2 screws and the air intake grill on the back of the unit. remove the drive belt. 2. Remove 2 screws on rear of top, slide top back and remove. 3. Remove 2 screws about a foot down on the inside on each side of the front cover. Remove four screws that secure the plastic control panel and the front panel that are right behind the control panel on the top. Disconnect the wiring harnesses, cut the nylon wire tie that is closest to the front cover. 3. lay unit on its back and and remove the two screws on the lower edge of the front panel, take your putty knife and slide it in the gap between the front panel and the dryer cabinet and release the two spring clips on both sides. Then you can lift off the front panel and control panel, set it to the side. 4. Remove the screw and the nylon guide from the center of the top front case crossmember. Remove the three screws on the inside rear of the drum, lift out the drum and set aside. 5. The drum pivot just sits in a nylon socket, pop it toward the top of the machine and lift it out, you may want to clean it good and re-lubricate it on reassembly. Disconnect the wires from the heating element and the heat sensor. 6. Set the cabinet upright and remove the four screws on the back side of the rear of the cabinet but not the two that are right in the center, they hold the pivot fixture and don't need to come out. The heater coil pan is now loose and ready for removal. 7. The seal between the filter housing and the blower housing was torn and this is an important part to have right, any air leak here will do the same thing as a dirty lint filter or plugged dryer exhaust and your new heating element will have a short, hot life. I pulled the old one off, scrapped the old glue off, applied the adhesive like the instructions on the tube say and after a few minutes installed the new seal then set the front panel to the side to let the adhesive dry. 8. The reassembly is just the reverse of the disassembly , use a couple nails or awls to help hold the dryer heater pan in place for screw installation and you might want to gentle squeeze the wire connecters if they feel loose, also check for clogged or kinked exhaust and stress the importance of cleaning the lint filter after EVERY load, it is small and all the air that cools the heating element must go through it, if is isn't maintained your new element won't last long. Have fun!
Read more...
Frigidaire Dishwasher SEAL
PartSelect Number PS9492299
Manufacturer Part Number 117158011
Fixes these symptoms
- Leaking
- See more...
Your Price
$44.87
In Stock
Frigidaire Dishwasher O-Ring - Rear
PartSelect Number PS420466
Manufacturer Part Number 154246901
Fixes these symptoms
- Leaking
- See more...
Installation Instructions
John from Herndon, VA
replaced dishwasher motor
Single-handedly. Tipped dishwasher on its side for easy access to water and electric connections. Went back together with no problems or leaks, washes quiter than ever.
Read more...
Related Frigidaire Dishwasher Parts
- All Frigidaire Dishwasher parts
- Frigidaire Dishwasher Brackets and Flanges
- Frigidaire Dishwasher Circuit Boards and Touch Pads
- Frigidaire Dishwasher Dishracks
- Frigidaire Dishwasher Dispensers
- Frigidaire Dishwasher Doors
- Frigidaire Dishwasher Filters
- Frigidaire Dishwasher Grilles and Kickplates
- Frigidaire Dishwasher Handles
- Frigidaire Dishwasher Hardware
- Frigidaire Dishwasher Hinges
- Frigidaire Dishwasher Hoses and Tubes
- Frigidaire Dishwasher Insulations
- Frigidaire Dishwasher Insulations
- Frigidaire Dishwasher Knobs
- Frigidaire Dishwasher Latches
- Frigidaire Dishwasher Motors
- Frigidaire Dishwasher Panels
- Frigidaire Dishwasher Pumps
- Frigidaire Dishwasher Racks
- Frigidaire Dishwasher Spray Arms
- Frigidaire Dishwasher Springs and Shock Absorbers
- Frigidaire Dishwasher Switches
- Frigidaire Dishwasher Timers
- Frigidaire Dishwasher Trims
- Frigidaire Dishwasher Wheels and Rollers