Snow Blower Starters
Popular Snow Blower Starters
Snow Blower Starter Pawl-Ratchet
PartSelect Number PS8942598
Manufacturer Part Number 281505S
The manufacturer-approved Ratchet Pawl (Starter Pawl) comes in a set of two (2). This part attaches inside the recoil assembly, and is used to engage the flywheel. if broken due to wear/damage it will have a hard time engaging the fly wheel, making the engine harder to start, and should be replaced. Installation is rated as "Easy" by customers, and will require a screwdriver, pliers and nutdriver. Refer to your make, model and diagram to ensure this is the correct part for you.This model is plastic and comes in white.
Installation Instructions
david from JERSEY SHORE, PA
blower housing on the customers log splitter broke.
blower housing on my brothers log splitter broke at the anchor points and caused the pull start to break and come apart. I was able to buy the parts and fix the log splitter for half the price of a new motor, saving him about $300.00.
Read more...
Snow Blower Gear-Pinion (Plastic and Aluminum Ring Gear)
PartSelect Number PS9066374
Manufacturer Part Number 695708
Snow Blower Plate-Pawl Friction
PartSelect Number PS9074726
Manufacturer Part Number 692299
Installation Instructions
david from JERSEY SHORE, PA
blower housing on the customers log splitter broke.
blower housing on my brothers log splitter broke at the anchor points and caused the pull start to break and come apart. I was able to buy the parts and fix the log splitter for half the price of a new motor, saving him about $300.00.
Read more...
Snow Blower Engine Starter Motor
PartSelect Number PS9138250
Manufacturer Part Number 795121
This starter motor is for lawn and garden equipment engines.
Starter motor spins the flywheel to start the engine.
Wear work gloves to protect your hands when installing this part.
Snow Blower Gear-Ring (Aluminum) (Services Plastic Ring Gear Only)
PartSelect Number PS9076854
Manufacturer Part Number 696537
Snow Blower Starter-Rewind
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill switch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light Read more...
PartSelect Number PS9064480
Manufacturer Part Number 693900
Installation Instructions
Dennis from EUFAULA, OK
Gas tank leaking, pull starter rivets worn, rope and rope bushing worn
The gas tank was a simple job, close the fuel shut off, remove fuel hose then back out 2 bolts on the mounting bracket. Reverse procedure to mount.To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill switch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light Read more...