Refrigerator Drawers and Glides

Popular Refrigerator Drawers and Glides

Your Price
$3.89
  In Stock
Refrigerator Crisper Cover Support - Front
★★★★★
★★★★★
78 Reviews
PartSelect Number PS2358880
Manufacturer Part Number 241993101
This crisper cover front support is used to keep the crisper shelf in place and may need replacing if the door will not open or close. This white, OEM part measures roughly 1 inch in diameter and can be used for the front and the rear support, as designed by the manufacturer, and mounts to the inside cabinet wall. Replacing this part is an easy repair, and will require a small flat blade screwdriver, a putty knife, and a soft hammer. Remove the crisper and shelf from the refrigerator before replacing the support. The crisper cover front support is held in place with a locking pin. To remove the old part, you will first need to push the pin into the interior of the cabinet using the screwdriver, and then you can pull the support out with a putty knife. If you cannot get the pin out you can use a flat-blade screwdriver to push it down and out of sight and it will not harm anything in your refrigerator After removing the pin and attaching the new support, simply use the soft hammer to lock the new pin in place.
Fixes these symptoms
Installation Instructions
Peter from Amherst, NY
Support studs were broken
Used pliers to remove the residual broken stud that was still attached to the wall of the refrigerator, and then just pushed the new part in place. The longest time was spent in removing the food and crisper drawers. Read more...
15% OFF
Your Price
$67.89
$79.56
  In Stock
Refrigerator Crisper Drawer with Humidity Control
★★★★★
★★★★★
405 Reviews
PartSelect Number PS11739119
Manufacturer Part Number WP2188656
The crisper drawer (Crisper Pan, Refrigerator Crisper Drawer) with humidity control is meant to keep your vegetables and fruit as fresh as possible by allowing you to regulate the humidity levels within the drawer. It attaches on the inside of your refrigerator to the bottom of the crisper shelf. This drawer can break from misuse or accidental damage. It is also subject to material fatigue over time. If broken or damaged, it may be difficult to slide the drawer in and out, and it should be replaced. This plastic drawer measures 14.92 inches long, 7.6 inches high, and 16.5 inches wide and comes in white/clear.
Fixes these symptoms
  • Clicking sound
  • Door Sweating
  • Door won’t open or close
  • See more...
Installation Instructions
JULIA from BRONX, NEW YORK, NY
replacing parts only
the prices you had were great, now I see there was an increase in the parts.
thank you
Read more...
13% OFF
Your Price
$104.89
$120.62
  In Stock
Refrigerator Crisper Pan
★★★★★
★★★★★
32 Reviews
PartSelect Number PS429854
Manufacturer Part Number 240337103
This manufacturer-certified Refrigerator Crisper Pan is a clear plastic pan which easily inserts into your fridge's crisper area in order to hold items. In some models of refrigerator this model is the same pan for both the meat and vegetable bins, but please note that this part is sold individually and not part of a complete kit. If broken then the part should be replaced. Refer to your user manual and model number to see if this crisper is right for your fridge. This bin measures approximately 11 inches deep and 22 inches long.
Fixes these symptoms
Installation Instructions
Melody from Hammond, IN
pan-crisper broke / drawer support rail broke
pan-crisper pan was easy because is just slide in. the drawer support rail just took a screwdriver to unscrew the screw and replace it with new rail and put the screw back in. The thing I like the best is the fast service of the parts to me. Read more...
Your Price
$44.89
  In Stock
Refrigerator Drawer Support Rail - Right Side
★★★★★
★★★★★
145 Reviews
PartSelect Number PS430917
Manufacturer Part Number 240530701
This manufacturer-certified drawer support rail supports the right side of the sliding drawer. It is a track that helps the drawer slide open and closed with ease. If you are having trouble opening or closing your fresh food drawer, check the support rails for any blockage, or visible damage. If the rail is damaged, it should be replaced to ensure no further damage is done to the drawer itself. The repair is straightforward: unscrew and remove the existing support rail, then fasten the new rail in place. This genuine OEM replacement part is made of plastic and is white in color. NOTE: This part is sold separately from the left side drawer support rail. The part measures approximately 16 inches long by 1 inch high.
Fixes these symptoms
Installation Instructions
Jane from Owosso, MI
broken refrigerator door shelves
snapped right on and removed screws, insert and replace screws. Read more...
Your Price
$50.67
  In Stock
Refrigerator Center Crisper Drawer Slide Rail - White
★★★★★
★★★★★
174 Reviews
PartSelect Number PS11757048
Manufacturer Part Number WPW10671238
This is a center crisper rail for your refrigerator. This part acts as a support rail for the crisper drawer by holding the center of the crisper frame. You will need to replace this part is if your current drawer is not opening or closing properly. This crisper rail is white and it is made entirely of plastic. It is roughly 13.5 inches long, and 2.5 inches wide. This is an easy repair which requires no tools.
Fixes these symptoms
  • Clicking sound
  • Door won’t open or close
  • Fridge and Freezer are too warm
  • See more...
Installation Instructions
Ruth from Roxbury, MA
Cracked & Snapped Center Crisper Rail
A very easy fix took all of five minutes Read more...
Your Price
$21.89
  In Stock
Refrigerator Center Rail
★★★★★
★★★★★
224 Reviews
PartSelect Number PS11752912
Manufacturer Part Number WPW10326469
This OEM Center Rail is a white plastic part which supports the crisper frame, which holds the crisper. Fifteen inches long and white in colour, if broken, the support may no longer hold properly. Refer to your model number and user manual to see if this part will be right for your appliance. This part is a very easy repair which only takes a few minutes and does not require any tools. Just slide the crisper drawers out, lift out the glass shelf, slide the new rale into place and replace the glass shelf and crisper drawers. This part is sold individually and not as part of a set.
Fixes these symptoms
Installation Instructions
Robert from Meriden, CT
Crisper frame center rail failure
Remove Crisper drawers from Bottom Shelf.
Remove glass from the top of Bottom Shelf.
Drop new Crisper frame center rail into slots on the top of the Bottom Shelf shelf.
Replace glass onto the top of the Bottom Shelf.
Slide drawers between left and right guides and the Crisper frame center rail.

Total repair time less than one minute.
No tools required.
Read more...
13% OFF
Your Price
$53.89
$61.97
  In Stock
Refrigerator Crisper Drawer With Handle
★★★★★
★★★★★
120 Reviews
PartSelect Number PS11739122
Manufacturer Part Number WP2188664
This OEM, clear convertible meat drawer can be used to store meats or vegetables and is designed for the lower portion of your refrigerator, generally. It has its own cold air duct to allow cold air from the freezer to flow into the drawer. You could have a broken or faulty drawer if you find that the food is kept within is spoiling or drying out quickly. The drawer should slide open and closed with ease. If your drawer will not easily slide open or closed, check the tracks that the drawer slides on. If the tracks are not damaged, the drawer itself could be at fault and should be replaced. Inspect it for visible damage like cracking or warping, which should be obvious. This part measures approximately 16 7/16 inches wide x 14 5/16 inches deep x 7 5/8 inches high and is a genuine OEM replacement part. It is sold individually. Note that there are several different types and options for the lower vegetable and meat drawers for your refrigerator, and you should check your user manual carefully to ensure that this is the drawer you are looking for.
Fixes these symptoms
Installation Instructions
Betty from Orinda, CA
Previous owners of the condo took the two drawers from the refrigerator
No repair, just slid the drawers in their places.
Since you had a diagram of the refrigerator parts, ordering the parts was easy and I was confident that the parts were the correct ones.
Read more...
Your Price
$26.89
  In Stock
Refrigerator Pantry End Cap Kit, LH and RH
★★★★★
★★★★★
375 Reviews
PartSelect Number PS11738134
Manufacturer Part Number W10874836
This manufacturer-approved Refrigerator Pantry End Cap Kit, also known as the Refrigerator Drawer Support, is a kit containing all parts of the Pantry End Cap. It snaps into place on the appliance’s pantry drawer to help contain the items inside and to keep your refrigerator door from sliding all the way out. It is rated as "medium" difficulty to install, is constructed of plastic and comes in white. If broken or missing, the pantry drawer will not stay in place and the part should be replaced. Refer to your user manual and model number to ensure this is the correct part for you. This kit includes both the right and left side end caps, as well as the pins that will hold them in place. To replace an end cap, remove the three screws holding it in place. Then, remove the pin and end cap, replacing the old end cap with the new end cap. In the past, the left and right end caps were sold separately, but the part has been updated and now includes both sides. The part is sold as a kit, and unfortunately, as such none of the parts are available individually.
Fixes these symptoms
  • Door won’t open or close
  • Fridge too cold
  • Noisy
  • See more...
Installation Instructions
Tim from Littleton, CO
The poorly designed deli drawer lid tab broke off
Removed the fruit & veggie drawers & the deli (pantry) drawer. Took out the 3 screws, removed the attached parts, put them on the replacement part, reattached it and put the drawers back in.

Here's the part I want to share: PartSelect had a expanded diagram showing the correct part and sufficiently detailed to figure out the repair before the part arrived. That's why I ordered from them. Secondly, I ordered the part Thursday morning--and the thing was sitting on my porch when I came back in from my evening out Saturday--2 days later!!!
Read more...
Your Price
$48.77
  In Stock
Refrigerator Drawer Support Rail - Left Side
★★★★★
★★★★★
57 Reviews
PartSelect Number PS430916
Manufacturer Part Number 240530601
This drawer rail supports the left hand side of the sliding drawer.
Fixes these symptoms
Installation Instructions
Jane from Owosso, MI
broken refrigerator door shelves
snapped right on and removed screws, insert and replace screws. Read more...
Your Price
$52.89
  In Stock
Refrigerator Crisper Glass Shelf Insert
★★★★★
★★★★★
56 Reviews
PartSelect Number PS429963
Manufacturer Part Number 240350608
Glass only. This glass insert measures 23.82 x 15.50-in. This is an authentic Frigidaire replacement part. The crisper shelf insert is designed by the manufacturer for use in refrigerators. This part is made of glass, and is placed over the crisper pan drawers. No tools are required when replacing this item. Simply remove the old part and slot the new one into place. This item is sold individually.
Installation Instructions
shun from madison, WI
broken pieces, thought would have to replace refrigerator.
Former tenants had broken glass bin cover and door shelf retainer. Online parts catalog was easy to use, pictures accurate, correct parts received promptly, fit is perfect. Price was couple bucks less than others. Thanks for saving us the cost of a new frig. Read more...

Refrigerator Drawer or Glides Brands