This EveryDrop Filter3 is certified to reduce the most contaminants with Triple Filtration Technology. Now, you and your family can enjoy the enriching benefits of cleaner, freshly filtered ice & wate...
The lower door closing cam is used in refrigerator doors, it can be located on the fresh food side or the freezer side. It helps hold the door open. This cam is made out of plastic, so it might crack ...
This Ice Maker (Icemaker Assembly, Complete Icemaker Assembly, Ice Maker Assembly, Refrigerator Ice Maker) can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located ...
The “Icemaker Control Assembly” (Module & Motor Assembly, Ice Maker Control Module, Icemaker Module, Refrigerator Ice Maker Module) is what controls the actions of your ice maker. The control turns th...
This is a refrigerator ice guide that is made entirely of clear plastic. This ice guide is located in the freezer door. Turn your refrigerator ice dispenser off before replacing the part. This is a si...
If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat. The function of the defrost bi-met...
This light bulb is a 120 volt, 25 watt incandescent appliance light bulb with a small base screw-in that fits in a variety of appliances such as microwaves, refrigerators, freezers, cooktops, or stove...
In this kit you will find the support, the ice door, spring, and delay. The heater ribbon is no longer needed and therefore will not be included with this part. This kit works in the dispenser chute t...
This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker whe...
$319.56
In Stock
Questions And Answers for KSCS25INSS01
Ask our experts a question about this model and we'll get back to you as soon as possible!
8 questions answered by our experts.
Sort by:
< Prev
1
2
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Cynthia
February 9, 2020
How many cubic feet
For model number KSCS25INSS01
Hello and thank you for writing.
This unit is 24.5 Cu. Ft.capacity. We hope this helps. Please contact us anytime if you require further assistance.
2 people found this helpful.
Was this helpful?
Thank you for voting!
JOANNE
August 22, 2023
I cannot remove the water filter below the freezer on my side by side refrigerator. The old cap broke and the I am unable to attach the new cap to the cartridge still in the refrigerator. I have tried turning the cap every way but it will not line up so I cannot remove the old cartridge to replace it. This is the first time this happened, I have replaced the cartridge many times in the past. Hope you can help. I even watched the video. No luck still. Thank you.
For model number KSCS25INSS01
Hi Joanne, thank you for contacting us. First, you may need to make sure you have pressed the water filter button on the left side of the cap before removing the filter. To install the new cap, you just have to give it a little clockwise turn, and it locks in place. If you are still unable to remove the filter, then you may need to check the filter housing, part number PS11748616, as it is most likely faulty. We hope this is helpful!
Hi Nancy, thank you for reaching out. Based on our research, your model has approximately the following dimensions:
Height: 71 1/2 inches.
Width: 35 11/16 inches.
Depth: 30 1/8 inches.
We hope this information helps!
Was this helpful?
Thank you for voting!
Todd
November 27, 2019
Fan with large blades bottom right side on back of base keeps running. Cleaned coils and back and front.
For model number KSCS25INSS01
Hello Todd,
Thank you for your question. We suggest replacing the fan motor itself under part PS11723174 for your model to fix the issue. Hope this helps!
My owners manual says the replacement water filter is a 4396711. Pg. 9, owners manual. I was also told by a repair company that replaced my ice maker the filter should be 439641. Which one is correct?
For model number KSCS25INSS01
Hello Dean, thank you for your question. The most recent updated filter number is EDR3RXD1. Please see the related part below for price, availability and installation help. I hope this helps.
removed flap door in front of icemaker...removed 3 screws with bolt heads...removed one additional screw with bolt head and ice unit slid out. I removed motor unit (pops out no screws). Replaced and had ice within 3 hours.
Remove the icemaker service door... gently pry the door pins from the hinge sockets. Remove the 3 screws from the under side of the icemaker with a nut driver (1/4"). Gently remove the icemaker . It's a tight fit between the top of the compartment and the icemaker lower support tray. Next, disconnect the electrical connector at the ri
... Read moreght side. You're done! Reverse procedure for installing. Good luck. Remember, your working with cold plastic...take your time and don't force too much.