This detergent suction kit, also known as a soap or chemical injection kit, is designed for use with a pressure washer. This is a genuine OEM part designed to inject soap into the water stream of your...
This thermal release valve is for pressure washers.
Thermal release valve attaches to the pump and releases the water and high pressure inside the pump if the water temperature exceeds normal oper...
This OEM outlet tube, also known as a hose connector, allows pressurized water to flow from the pump of your pressure washer to the nozzle. Connecting the hose to the handle assembly and the spray wan...
(25 ft., 3000 psi)
This water hose is for pressure washers.
Water hose carries water from the pump to the spray wand.
Wear work gloves to protect your hands when installing this part.
Tank is held in place by 2 nuts and 1 bolt. These were removed and tank lifts off. Installed filter assembly and fuel hose to bottom of new fuel tank. You must install fuel hose clamp to tank connection before installing new tank. Install the other end of fuel line to carburetor on engine with other clamp and you are finished.
Repair was easy, however had to u tube issue for proper orientation of parts as it did not come with any instructions. Wished I had two as shipping was twice as much as part. Very satisfied.
1) Loosen engine assembly from frame. 2) Remove fuel tank, hoses and disassemble other hoses and components. 3) Attach new hoses to carburetor. 4) Reassemble fuel tank, engine and carburetor components. 5) Re-center motor engine assembly onto washer frame and tighten nuts, bolts and washers as needed.