Maytag Dishwasher Dispensers
Popular Maytag Dishwasher Dispensers
Maytag Dishwasher Detergent Dispenser
Remove all screws around the stainless metal shroud inside the door. DONT remove the hinge screws.
Torx bit required.
Unplug detergent dispenser and place outer door assembly aside. Dispenser has small clips holding it in, top, bottom and sides I believe. Push these in, dispenser falls out into dishwasher.
Insert new unit, reverse all steps. Done.
Dont for get to reattach the wires! Read more...
PartSelect Number PS11731570
Manufacturer Part Number W10861000
Detergent dispenser W10861000 is an original equipment manufacturer (OEM) part that fits some Whirlpool, KitchenAid, Maytag and Amana dishwashers.
Detergent dispenser W10861000 attaches to the inner door panel and holds the dishwasher detergent and rinse aid in covered compartments.
This dishwasher detergent dispenser measures approximately 5 inches wide and 4.5 inches high.
Fixes these symptoms
- Door latch failure
- Not cleaning dishes properly
- Will not dispense detergent
- See more...
Installation Instructions
David from Swanzey, NH
Detergent door was not locking closed
Super simple.Remove all screws around the stainless metal shroud inside the door. DONT remove the hinge screws.
Torx bit required.
Unplug detergent dispenser and place outer door assembly aside. Dispenser has small clips holding it in, top, bottom and sides I believe. Push these in, dispenser falls out into dishwasher.
Insert new unit, reverse all steps. Done.
Dont for get to reattach the wires! Read more...
Your Price
$127.86
In Stock
Maytag Dishwasher Detergent Dispenser Assembly
PartSelect Number PS11750167
Manufacturer Part Number WPW10199696
This part releases the detergent and rinse aid into the dishwasher. Light grey in color. The detergent dispenser attaches to the inner door panel and holds the dishwasher detergent and rinse agent in a covered compartment.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Craig from Austin, TX
latch on dispenser cover broke
Printed door assembly parts list and photo from KitchenAid website. (With the absence of instructions, it was a big help.) Remove door cover. You'll need a star driver bit. Remove the old dispenser. Note how the metal clamp and black cover sheet are positioned. Install the new dispenser. Insure the wiring harness is snapped in place. Replace the door cover. Not difficult; just some patience. One more hint ... be careful when taking the door cover off and you won't have to disconnect any other wiring.
Read more...
Maytag Dishwasher Detergent Dispenser
PartSelect Number PS11773088
Manufacturer Part Number W11032769
Fixes these symptoms
- Door latch failure
- Leaking
- Not cleaning dishes properly
- See more...
Your Price
$27.31
In Stock
Maytag Dishwasher Soap Dispenser Cover
PartSelect Number PS11741342
Manufacturer Part Number WP3378138
This part covers your soap dispenser and is spring loaded.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
KEVIN from PLAINFIELD, IL
soap dispenser door/spring broken
removed old parts and re-installed new parts. The spring is a little hard to get to the right point without a jewelers screwdriver, after that everything worked fine.
Read more...
Your Price
$12.99
In Stock
Maytag Dishwasher Pin (Lid Hinge)
PartSelect Number PS11741308
Manufacturer Part Number WP3372028
The lid hinge pin or detergent lid pin on your dishwasher helps dispense your dish detergent when your dishwasher is running. The pin fits with the dispenser lid and allows the lid to pop open and dispense detergent. It is a small, plastic pin that is approximately 3 inches in length. Due to its small size, the pin can be damaged relatively easily, and if your pin is broken or missing, it will need to be replaced. This product is sold individually.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Not cleaning dishes properly
- See more...
Installation Instructions
HAROLD from FISHERSVILLE, VA
Worn out spring on detergent release box lid
First, examine very carefully how the old spring relates to the detergent release box lid. Note that the top of the spring has a square-end upside down "U" . This rests on a small ledge on the detergent box. Also note that on either end of the spring is a straight extension of the spring wire. These two "legs" must rest on the inside of the edge of the detergent box. Second, use a flat blade screw driver to pry the LID hinge pin from the mounting "posts. Remove the pin, first noting the position of the spring. Reassemble the spring on the hinge pin in reverse order. Then snap the lid onto the spring using the two mounting "posts". NOTE: I used a very fine needle nose pliers to move the two spring "legs" behind the detergent box edge after I had mounted the lid. Flip the lid down to test if the spring pressure on the lid can be felt. Harold Kitzmann, Fishersville VA
Read more...
Your Price
$11.09
In Stock
Maytag Dishwasher Soap Cup Latch Kit
You have to take off the nine star pointed screws. So you need a special screwdriver or I had a socket set of them and I used a ratchet to make it easier. I think there are nine of them around the base of the door. Then remove the door and set it on the counter. Flip it over and there is a small plastic cover that has to be removed from the back of it, and it is easily removed by gently pulling on it.
Now comes the difficult part. There is a locking piece on it that holds the latch onto the door by interlocking with a piece on the back side of the door. I took a pair of wire snips and just cut the old interlocking piece off. This way I didn't have to try and slide the two interlocking pieces apart.
When you go to put the new piece on before you interlock them make sure they are put on right. Specifically the latch is pointing the right way to seal the detergent door. Otherwise it can be a pain to separate the interlocking pieces again. (which is why I cut it off the old one).
Then you're done. Just put it all back together. Read more...
PartSelect Number PS382922
Manufacturer Part Number 676413
This soap cup latch kit, used in a dishwasher, will keep the dispenser cover closed. If your dishwasher will not dispense detergent, there is a door latch failure, the dishes are not cleaning properly, or there is leaking, then this kit can be the solution to your symptoms. The tools required for this replacement are a #15 torx bits, a small blade screwdriver, and slip joint pliers. First locate the soap box and remove the latch on both sides. Next step is to remove the screws in the inner door panel and remove the plastic cover at the back. Remove the old latch assembly and add the new one. Make sure to unplug your dishwasher before beginning this installation project.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Steven from Edmond, OK
Latch broke on dishwasher
Look at the exploded parts diagram, that parts select provides on their website.You have to take off the nine star pointed screws. So you need a special screwdriver or I had a socket set of them and I used a ratchet to make it easier. I think there are nine of them around the base of the door. Then remove the door and set it on the counter. Flip it over and there is a small plastic cover that has to be removed from the back of it, and it is easily removed by gently pulling on it.
Now comes the difficult part. There is a locking piece on it that holds the latch onto the door by interlocking with a piece on the back side of the door. I took a pair of wire snips and just cut the old interlocking piece off. This way I didn't have to try and slide the two interlocking pieces apart.
When you go to put the new piece on before you interlock them make sure they are put on right. Specifically the latch is pointing the right way to seal the detergent door. Otherwise it can be a pain to separate the interlocking pieces again. (which is why I cut it off the old one).
Then you're done. Just put it all back together. Read more...
Maytag Dishwasher Soap Cup Door Latch and Gasket
PartSelect Number PS1960445
Manufacturer Part Number W10131752
If the soap cup door latch and gasket is malfunctioning, the dishwasher door will leak. You will find this part mounted to the inside inner door panel. To access this part you will need to take off the door panel. Once you have this removed you should be able to see how the old part is in place. You will need to remove the wax motor to complete the installation of this part. Consider applying a small amount of sealer to the flat part of the latch, which will ensure a tighter seal.
Fixes these symptoms
- Door latch failure
- Leaking
- Will not dispense detergent
- See more...
Installation Instructions
Bernard from Williamsport, PA
Water Leak at right side bottom of the dishwasher door
After dissassembling the unit to discover the leakage source I determined that it would do best to replace the top three contributors to the problem as listed by you. Disassembly, parts replacement and reassembly was straight forward and a few hints garnered from your good instructions and assembly blow-up drawings made the job simple with the most difficult task being the removal of the adhesive foam gasket at the bottom of the door's interior. After scraping as much of the deteriorated foam away as possible with a plastic scraper I used some of my wife's nail polisher remover and a clean-up rag (being careful not to get the remover on plastic parts)and soon I had the adhesion area surface clean and ready to receive the new seal. With close attention to clean up of residues left behind from detergent and water and care taken with part installation and reassembly it no longer leaks and I hope to get another 10-15 years of leak free operation out of the dishwasher
Read more...
Maytag Dishwasher Lower Detergent Dispenser Actuator Assembly
PartSelect Number PS392727
Manufacturer Part Number 8193646
Fixes these symptoms
- Door latch failure
- Will not dispense detergent
- See more...
Maytag Dishwasher DISPENSER
PartSelect Number PS11738149
Manufacturer Part Number W10876529
Fixes these symptoms
- Will not dispense detergent
- See more...
Related Maytag Dishwasher Parts
- All Maytag Dishwasher parts
- Maytag Dishwasher Brackets and Flanges
- Maytag Dishwasher Caps and Lids
- Maytag Dishwasher Circuit Boards and Touch Pads
- Maytag Dishwasher Dishracks
- Maytag Dishwasher Ducts and Vents
- Maytag Dishwasher Handles
- Maytag Dishwasher Hardware
- Maytag Dishwasher Hinges
- Maytag Dishwasher Hoses and Tubes
- Maytag Dishwasher Latches
- Maytag Dishwasher Motors
- Maytag Dishwasher Panels
- Maytag Dishwasher Pumps
- Maytag Dishwasher Racks
- Maytag Dishwasher Seals and Gaskets
- Maytag Dishwasher Spray Arms
- Maytag Dishwasher Springs and Shock Absorbers
- Maytag Dishwasher Switches
- Maytag Dishwasher Wheels and Rollers