Jonsered Cultivator Parts

Popular Jonsered Cultivator Parts

Your Price
$3.99
   In Stock
Jonsered Cultivator Clevis Pin
★★★★★
★★★★★
2 Reviews
PartSelect Number PS9009427
Manufacturer Part Number 532132673
This clevis pin is an OEM replacement part that is compatible with various makes and models of tiller and is sold as an individual part. The purpose of this pin is to snap or break under a certain amount of pressure if your tiller is jammed, to protect the more valuable components of your tiller. Measuring at approximately 2-inches long and made of high-quality metal, replacing this pin should only require pliers to swap out the old pin for the new.
Your Price
$48.56
   In Stock
Jonsered Cultivator Control, Throttle
PartSelect Number PS9014784
Manufacturer Part Number 532189482
Your Price
$7.87
   Special Order
Jonsered Cultivator Bearing, Shaft, Ground Drive R.H.
PartSelect Number PS9016290
Manufacturer Part Number 532143008
Your Price
$34.86
   In Stock
Jonsered Cultivator Cable, Clutch
PartSelect Number PS9011918
Manufacturer Part Number 532159231
This clutch cable is designed for use with various models of tillers, and is constructed of metal, with a durable plastic insulation. The purpose of this cable is to control the primary drive function of your equipment, so when it is engaged, the tiller moves, and when it is disengaged, the tiller stays stationary. This cable is connected to a lever on the handlebar, and to a mechanism on the engine, with the cable acting as the connector. If your equipment has issues with engaging the clutch, or if the cable is frayed and damaged, the cable needs to be replaced. To replace this cable, use a screwdriver or wrench to disconnect it from the lever, before removing it from the engine mechanism. Then simply install the new one where the previous one was connected.
Installation Instructions
David from SKANDIA, MI
Spring on clutch cable broke
Remove L. wheel.
Remove guard shield.
Remove old cable.
Install new cable.
Adjust throw on cable.
Put all parts back and test
Read more...
Your Price
$16.18
   On Order
Jonsered Cultivator Tine, Inner, L.H.
PartSelect Number PS9285516
Manufacturer Part Number 532006554
Your Price
$7.46
   In Stock
Jonsered Cultivator Pin Spirol Flared
PartSelect Number PS9013175
Manufacturer Part Number 532164329
Your Price
$34.86
   In Stock
Jonsered Cultivator Chain #35-50 Pitch
PartSelect Number PS9008326
Manufacturer Part Number 532102134
Installation Instructions
richard from MECHANICSVLLE, VA
broken drive axle chain
removed engine, sheet metal, handle bars, and tines. Seperated transmission case and replaced broken chain. This is not difficult it's just time consuming. A tiller repair shop would charge about $400 to do this job. It cost me $40 for a chain and gasket, Both fit perfectly, great service. Thanks Read more...
Your Price
$7.87
   In Stock
Jonsered Cultivator Grommet, Rubber (AYP part number)
PartSelect Number PS9476245
Manufacturer Part Number 532109313
Your Price
$95.89
   In Stock
Jonsered Cultivator Kit, Bearing
PartSelect Number PS9013186
Manufacturer Part Number 532165140
This OEM kit includes all the necessary hardware, including new bearings, oil and rubber seals, and rivets, to replace the tine shaft bearings on your tiller or cultivator. The tine shaft bearings support the tine shaft inside the gear case of your machine. If the bearings are damaged, you may experience rattling or squeaking noises, excessive vibrations, and difficulties in maneuvering. Uneven tilling or cultivating is a clear indication that the bearings need replacement. To locate and replace your tine shaft bearings, consult your user guide as they can be found on either side of the tine shaft. It is commonly found inside the gear case. You will need to remove any retaining rings holding the bearings in place with pliers or screwdriver. You may need to use a penetrating oil if the bearings are stubborn. Please note that this kit is sold separately from the tine shaft.
Your Price
$6.21
   In Stock
Jonsered Cultivator Thrust Bearing Race
PartSelect Number PS9007713
Manufacturer Part Number 532001370

Jonsered Cultivator Appliance Types

Related Jonsered Cultivator Parts

Popular Jonsered Cultivator Models

Below are the most popular Jonsered Cultivator models we have. Enter your model number in the search box to find your model.