General Electric Washer Motors

Popular General Electric Washer Motors

Your Price
$72.39
  In Stock
General Electric Washer Drain Pump and Motor Assembly
★★★★★
★★★★★
35 Reviews
PartSelect Number PS8768445
Manufacturer Part Number WH23X10030
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. If you notice that your washing machine will not drain, there is a good chance that you will have to replace the drain pump. The drain pump is located inside the washing machine, near the bottom. To access the drain pump for this repair, you will need to remove the front panel. Before you begin this repair, be sure that the power source is disconnected and the water source is shut off.
Fixes these symptoms
Installation Instructions
Gerald from Midlothian, VA
Washing Machine was not draining water from tub.
1. Drained the wash tub by taking the drain hose from the back of the washing machine and dropping it below the tub - water flowed out of hose a lot easier than trying to suck water out of tub using a pump (tried this on the first time I tried to fix washer). (Washing machine on 2nd floor of house and didn't want water running on floor)
2. Removed the 2 bolts holding the Pump/Motor assembly to the machine.
3. Removed both hose clamps on the Pump/Motor assembly and removed Pump.
4. Attached the new drain inlet hose to the pump and then to the tub with the original hose clamps.
5. Attached the drain hose to the pump and then plugged in the 2 wires for the pump.
6. Plugged in the washing machine and everything worked.

NOTES:
1. Hardest part was working with hose clamps (spring type clamps) in the tight space under the machine.
2. Easier to fix since I pulled machine apart a few days before - removing the clog in the pump/motor assembly only to get everything back together to find out that the motor was dead. Still well worth the time and effort due to not having to go out and buy a new Machine...
Read more...
Your Price
$238.72
  In Stock
General Electric Washer Motor and Drain Pump
★★★★★
★★★★★
13 Reviews
PartSelect Number PS1766031
Manufacturer Part Number WH23X10028
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. This pump has sound isolation mounting washers and a filter.
Fixes these symptoms
Installation Instructions
Trent from Shreveport, LA
Washing machine would cease functioning at the spin cycle and would not drain.
Remove the front coverfrom the machine. This is done by removing the 3 screws at the bottom of the panel. The panel then drops down and pulls straight off. The pump is located on the front right wall of the of the machine. You will notice a 2-3 inch diamete threaded cap on the right side of the front wall of the machine. This is the front of the pump and access to the filter. Place a large bucket under this cap and slowly loosen the cap. All of the water remaining in the machine will begin to drain (this could be a lot of water. Do not remove the cap completely so that you can quickly stop the flow of water if needed). Once all water is drained from the appliance, Disconnect the two hoses from the pump using a pair of pliers to looses the presure clamps, sliding the clamps back an then pulling off the hoses (be careful of any remaining water in the hoses). Then remove the two screws from the rear base of the pump that secure it to the bottom floor panel of the washer. Slide the pump slightly to the rear to free it from the fittings on the front wall of the machine and the lift the pump up. At this point, firmly pull out the wiring harness plugged into the top right side of the pump. Install the new pump by plugging in the wiring harness and resecuring the pump. Plug in the machine and run on the rinse and spin cycle to test. Read more...
Your Price
$215.96
  In Stock
General Electric Washer Drive Motor and Pulley
★★★★★
★★★★★
2 Reviews
PartSelect Number PS11699355
Manufacturer Part Number WE17X22217
Your Price
$252.81
  In Stock
General Electric Washer Remote Style Pump with Motor
★★★★★
★★★★★
2 Reviews
PartSelect Number PS417325
Manufacturer Part Number 131268401
Use this with either a top load or front load washer. This pump has an horizontal mount.
Fixes these symptoms
Installation Instructions
Thomas from Walpole, MA
Pump Motor Failed
First, remove the 2 screws that hold the lower front cover in place, remove the cover and disconnect the plug and the ground wires from the pump. Next attach the washing machine drain hose to a wet vac, since even if the machine is empty, there will still be water in the outer tub and the pump. Suck the whole thing dry, remove the 2 bolts that hold the cover onto the pump, use a pliers to remove the 2 hose clamps, remove the hoses (no mess because of the vacuum). Remove the 2 screws that hold the pump to the base of the washer and remove the pump. Save the mounting bracket from the bottom of the pump. Orient the outlet on the new pump to match your old one if needed, instructions to do this are included with the new pump. Install the mounting bracket onto the new pump. Mount the pump to the washing machine base, reconnect the hoses, the cover and the wiring. Put the drain hose back into your drain. Run the machine, check for function and leaks. If all is well, replace the lower cover. Don't forget to tell your wife that the job was a whole lot harder than it looked. Read more...
Your Price
$322.44
  In Stock
General Electric Washer Drive Motor & Inverter Board
PartSelect Number PS2577717
Manufacturer Part Number WH20X10055
The inverter changes the rotation of the motor and output by using sensors in the appliance. It makes for quieter and shorter cycles.
Your Price
$386.36
  Special Order
General Electric Washer MOTOR Assembly KIT
PartSelect Number PS11736876
Manufacturer Part Number WH49X25041
Your Price
$350.69
  In Stock
General Electric Washer MOTOR
★★★★★
★★★★★
1 Review
PartSelect Number PS11725315
Manufacturer Part Number WH20X23194
Your Price
$531.03
  In Stock
General Electric Washer Main Control Board with Tub Shield Motor
PartSelect Number PS11767531
Manufacturer Part Number WH49X25738
Your Price
$217.47
  Special Order
General Electric Washer STATOR
PartSelect Number PS10055828
Manufacturer Part Number WH39X20678
Your Price
$154.02
  In Stock
General Electric Washer STATOR
PartSelect Number PS8757178
Manufacturer Part Number WH39X10013

Related General Electric Washer Parts