Dishwasher Bearings
Popular Dishwasher Bearings
Dishwasher Wash Arm Bearing
PartSelect Number PS9492561
Manufacturer Part Number 807035801
This part is the replacement wash arm bearing for your dishwasher. It is made of black plastic and is approximately 1 1/4 inches in diameter. The wash arm bearing allows the wash arm to rotate when the dishwasher is operating. A broken bearing can make the wash arm difficult to rotate, and when this occurs, your dishes may not be washed properly. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.
Fixes these symptoms
- Not cleaning dishes properly
- See more...
Your Price
$13.69
In Stock
Dishwasher Spray Arm Seal
PartSelect Number PS11745444
Manufacturer Part Number WP8268433
This seal is located between the spray arm and the water feed tube.
Fixes these symptoms
- Leaking
- Noisy
- Not cleaning dishes properly
- See more...
Installation Instructions
Clifford from Centennial, CO
Glasses in the top shelf had food bits - not rinsing well
The most difficult part of this was figuring out the problem was with the middle spray arm - that it was not spinning (and thus not rinsing the top dishes). I could spin it by hand fine - but if I watched its position while the machine was running (open/close the door) I saw it wasn't moving. I took out the top shelf (with spray arm attached) and connected it to the garden hose. I could see then that the arm was sagging and hitting the rear connection, preventing it from spinning. To replace I removed the plugs from the top shelf side-rails (bend the rail open with your thumb and tip the plugs out of the rail to the right for the left rail, to the left for the right rail. this is easier than pulling them out the end of the rail). Slide out the top shelf. Turn over, remove the phillips screw and pull off the manifold, and middle spray arm. Replace with the new parts. I also replaced the top spray arm (which was very loose, and probably not spraying well because it was so loose). For this I unclipped the top feed tube and pulled off the old sprayer. Put a towel in the bottom rack of the washer so you don't drop the little pieces into the pump below. The top spray arm simply snaps in with the two connectors (the pointy one attaches through the feed tube).
Read more...
Your Price
$12.24
In Stock
Dishwasher Upper Spray Arm Bearing
PartSelect Number PS2353863
Manufacturer Part Number WD01X10410
This is the upper spray arm bearing for your dishwasher. The spray arm fits onto the spray arm bearing, which allows it to spin during the cycle. If your dishwasher is not cleaning dishes properly, or is making a lot of noise during operation, it could be the result of a damaged spray arm bearing. This part is made of white plastic and is approximately 1 inch long and 1/2 inch wide. This part is sold individually and is a genuine OEM part from the manufacturer.
Fixes these symptoms
- Noisy
- Not cleaning dishes properly
- See more...
Installation Instructions
Thomas from EASTON, KS
Dishwasher Door Hinge Lever Bearing
PartSelect Number PS8697061
Manufacturer Part Number 00165296
This door hinge lever bearing is for dishwashers. Door hinge lever bearing allows the door hinge lever to move smoothly.
Your Price
$6.90
In Stock
Dishwasher Bearing, Spring, (2)
PartSelect Number PS11741317
Manufacturer Part Number WP3373234
Sold Individually. This is what your door spring would hook into and it prevents the metal spring from rubbing against the metal on the side of the door.
Fixes these symptoms
- Door latch failure
- Door won’t close
- See more...
Dishwasher Tine Row Clip
PartSelect Number PS8727384
Manufacturer Part Number 00611472
This tine row clip is for dishwashers. Tine row clip holds the tine row in position.
Dishwasher Tine Row Pivot Clip
PartSelect Number PS8727385
Manufacturer Part Number 00611473
This tine row pivot clip is for dishwashers. Tine row pivot clip attaches the tine row to the dishrack and allows the tine row to pivot up and down.